As a rule I think the less wrap the better.
I used baby powder followed by aproximately 15-17 inches of theraband - the gray color.
Do a 50% overlap for each wrap around and start the wrap aproximately an inch below the head.
I’d use a slight angle (30%) for each time around.
When complete i’d secure it with a small (aproximately one inch) piece of scotch tape.
The final look would be that my entire penis expect for the top portion ( my head and just below) would be covered.
Then I connected the hanger, I would try to get it as low as possible toward the based and really took my time making sure the hanger was secure without pinching before adding the weight.
I started will less weight to allow the hanger to find it’s place, then would remove the weight tighten it somemore and add the weight again.
The first few minute is sometimes uncomfortable however when my penis adapted to the stress I would add more weight then get into my session.
If the wrap was not right then the hanger fit was also not right.
Typically the whole process took less than five minutes.
Hope this helps.
zep