Selecting Your Cylinder Size

Those brake bleeder pumps are the same pump as leluv or pumptoys, but they don’t come with a quick disconnect connector that you need to connect to the pump hose to the cylinder.

Leluv pumps are professional quality pumps that will do the job and last a long time and cost a lot less than Pumptoys. I always recommend Leluv for guys starting out. I also recommend that new guys buy a turn key system that is ready to go out of the box instead of trying to piece a system together from multiple sources.

That Leluv system from ebay does cost and extra $25 to ship to Canada.

Hey guys! Wanting to work on length. I am slightly over 6 for base EG, and just shy of 7 BPEL. I wanted to order a Luluv pump but wanted to make sure I ordered the correct one. I also noticed that the recommended ones didn’t come with the rubber insert, is that something that I should add? Thanks for help!

You should order a pump with a 9”X2” or 9”X2.25” cylinder depending on if you are pumping for length or girth as shown in the sizing table in the 1st post of this thread.

What rubber insert are you talking about?

Thanks for reply.

The pump sleeve was the insert I was talking about.

The LeLuv cylinders are made with a flange on the bottom and no extra sleeves are needed for sealing.

If you really want length and dont have a (big )curve I would order the 1 7/8 inch diameter pump from thickwall cylinders. They say 1,75” on their homepage but it is milimetrically correct at 48mm (UK manufacturer using mm not inches) so they are bigger and will fit exactly 5,94” girth.

Obviously the best option for gaining length is totally packing the cylinder girth wise, which a 5,94” circumference cylinder would allow you to do faster than a much bigger 2” cylinder which is 6,282” circumference. Especially if you have less girth higher up on the shaft you should not go for a 2” cylinder if you want length.

I have almost 6” exactly base girth and I have switched to this Thickwall 48mm cylinder.

I recently bought another pump. I have 9x2 and 9x1.5. Is it optimal to alternate between the two. Say using the smaller cylinder for one session and the bigger the next?

That is a big size difference between the 2 cylinders. What is your erect girth near the base?

Sorry put the wrong size. 1.75 instead of 2

What you want to do is start your session with the 1.5 and after you pack it, switch over to the 1.75 and continue with your session.

Thank you

Hey guys!
Got my LeLuv pump today and hit my first session at 5hg for 10 minutes.

What a different experience than the Bathmate. I love having control!

Couple questions.

Where is the quick release valve? Do I just disconnect the tube?

This thing is tight post pump. Tight enough, where I wouldn’t be able to go back in after session. I am going for length, is that ok?

Thanks!

the tighter the better for length, just make sure to make a mark on the cylinder to measure your length.

Hi everyone, I’m looking to gain girth only , my beg is 5” my mseg is 4.8” , so should I get the 2.0” cylinder ? And how much expansion will I get after the first session?

Get the 1.75. Who knows how much expansion you’ll get. Everyone is different.