blank spot on ruler

Alright folks. You know a newbie when he asks a question like this…
When you measure your penis, are you supposed to add that 1/5 of an inch that’s at the beginning of every ruler? I was considering cutting off that bit with a saw, but then I thought that If I do that, I won’t be consistant with the other members measurements. I don’t want to do it if it’s considered “cheating”, but it would be nice to have absolutley accurate measurements.

Is this a dumb question?

Thanks

The question is not dumb nor is this the first time it has been asked. I use a plastic see thru ruller that I removed that extra bit from with sandpaper.

What’s with ruler makers? Are they conspiring to make us feel smaller?

The plastic ruler I use is about 20 years old. It doesn’t have any dead space at the beginning. It’s accurate. I’ve checked it against several good tape measures to be sure, and the lines have always matched up exactly.

Cut yours off and sand/grind the end until it matches a tape measure. Then write the president of the company and ask him how long his dick measures using the defective ruler made under his leadership.

:D :D :D

LOL

I guess that answers that!

Thanks Guys!

Does everyone sand theirs? I was going to but thought it might always be a bit rough, and also I don’t have any sandpaper.

I just measure the extra bit and add it onto measurements.

I have thought about this but never worried about it. I just measured the gap at the start and it is 1/4. Cool, but measurements are merely a means of judging gains, the actual number doesnt mean shit to me.

SS4

Good point. At least if you have a terrible measuring instrument, perhaps just a bit of wood with a mark on it, at least you can see gains.

You could make your goal length out of a bit of wood, then use that, and see yourself getting closer and closer until you do it.

That’s a nice bit of visualisation.