What a complete waste of time!
I got everything ready, cut the tube down to size, got the moulding powder ready, fired up some porn and put on my cock ring.
Then it all went wrong - Firstly, it says you only have two minutes before the moulding powder completely sets. And in this time you have to mix the moulding powder with water, pour it into the tube and then insert your cock until it finally sets completely. So I quickly mixed the powder with the water keeping my eye on the time and then poured it into the tube, I cut the tube to 7” as I’m around 6.8” maxed out. First off, it didn’t even fill the tube, it was about an inch from the top. God knows what I’d have done if I was 9” for instance! So, obviously adding more water than the amount stated in the instructions would have helped, of course I wasn’t to know this.
Secondly, they say as soon you’ve mixed the mould and poured it into the tube to insert your penis as it more or less sets straight away. Well, I could have mixed the powder, poured it into the tube, inserted my penis into the tube, had a cup of tea and read the paper by the time it had set. Sure, it sets quickly but not as quick as they make it out to be. If I would have known this, I would have poured the mix into the tube and waited until the mix began to set before inserting my penis.
So, because they tell you to insert your penis straight away the mix is still pretty runny and hasn’t began setting yet, the mix just all drips out and half my penis wasn’t even covered with the mix.
They could have made those points a bit more clear in the instructions.
I’ve found a website that sells the mixing powder cheap so I’ll order a few bags and have another go. At least this time I know what to expect and hopefully it should all go to plan.