How to make a Maxxtender?

I searched but couldn’t find much about this. I’m very interested in its simplicity, has anynone made this extender yourself? I’m wondering what could be used to make the body?

I made it and it is simpler done than said. You just need two (or more) pieces of plastic pipe, one 5,5 cm diameter, the other one just slightly smaller. You drill holes at the center of boths side and then you put the smaller pipe inside the bigger, so they can slide like a telescope. The string I used was a nylon cord about 4mm diameter. The noose can be troublesome for some guys.

Thanks marinera, that’s what I am talking about. I went to the plumbing store and they said there were only the 4.8 cm and 6 cm diameter size, not really close. I’ll try to find some way to make it work. May be I’ll try to shrink the diameter of the bigger one, and replace the noose with a sillicone vacuum cap and sleeve.

Go to another store, there are pipes of all the sizes.

hi marinera, I’ve a question regarding using the max extender: do you think the maxxtender is essentially a stress-relaxation device? About stress-relaxation: Do you think the more length the penis can be stretched to - the more force needed to stretch it further in the next and later sessions?

Sorry my terrible english, this is for example: Today my manual stretch session has delivered a stretch a full inch longer than my FSL after several rounds of “relaxation, increase stretch, relaxation, increase stretch, relaxation…the question is: The next day, If I stretch it 1.5” longer than my FSL, do the force applied increase? (comparing to the force yesterday)

Yes.

No, the other way around should happen: with the same force, you should be able to stretch further than before.

Thank you so much :)

No problem.