How to measure the Penis

BPEL
E Q
EB PL

There are so many other words are used when some people talk there Penis length and girth

Please any one can post the full meaning and “HOW TO MEASURE THE PENIS LENGTH AND GIRTH (WIDTH) “
IT REALLY HELP FULL FOR ME AND NEWBIES ALSO
THANK

Okay.
BPEL stands for bone pressed erect length.
To get this just press a ruler into your body at the top of your penis to get the full size of your penis. This measurement will be used here to report your gains, don’t tell a woman this size.
The size you tell women will be your NBPEL or non bone pressed erect length, you will measure in the same way but do not press into the bone, just measure the amount of penis you can see.
EG stands for erect girth, this is generally understood as middle section erect girth, or the distance around the middle of your penis, measure this with a tape measure.
EQ stands for erection quality, you do not need to measure this.
If you will take careful notice you will see that as I carefully rearrange the letters of EB PL I get… BPEL!
There are many many more acronyms used here so kindly visit a few of the wonderful newbie threads we have on display.
Try clicking the large bold link at the top of the newbie forum :)

Thank you,
Caboose.
By the way where are you from? I like the way you talk.

P.S All measurements are to be taken from the top apart from EG.

Hey I have a question..

I’m sorry if this is in the wrong place or has been asked or answered before, but I can’t seem to find what I’m looking for, soooo..

I was wondering about the ideal size measurements. The general consensus is that 8x6 is the ideal dicks size, BUT how are we measuring this one? Is it 8NBP or 8 BP?

The magic 8X6 is 8 NBPEL

I am not sure but I think it can be BP if your fat pad is very low.

It should be pointed out that a correct BP measurement requires to push the ruler as hard as possible into the pubic bone. If one pushes the ruler into the body right at the top of the penis then he misses the pubic bone and gets a higher (but incorrect) measurement. The pubic bone is a little higher (~1/2”) and one should feel the harder contact. If we aim for even more precision, we should notice that the pubic bone is like an inclined plane, so pushing the ruler against the lower part of the pubic bone yields a higher value than pushing against the top part of it.

- Be consistent with always placing the ruler in the same position

- Press as hard as possible to be consistent and avoid doubts.

This is right and has got me thinking.

What if some forms of PE causes our ligs to loosen thus lowering the penis exit point from the body? (NOT the erection angle, I know mine hasnt changed, but I believe my penis shaft exits LOWER on the body although Im not sure)

If this is the case then youre automaticly measuring lower with the ruler each time your penis has lowered (Because of this you dont notice it) and it is giving you bigger measurement.

Pleasediplease, if you hover your cursor over abbreviations such as BPEL it will reveal the entire word bone pressed erect length.

Agreed.

The question is, how erect to measure at. Assuming full erectitude.. I kinda have to edge to get there (or other things similar). Because at edge I have most blood pumping into the entire volume. However, if I go too far, I seem to loose the ability to get that max push. I can’t seem to keep a max “rock”, if you will, for more than a few seconds without manual stimuli. Is this an EQ issue, or is that how everyone else measures? I mean there is a good almost 0.25-0.5 inch difference between my pretty hard and my max hard edging. Head doesn’t seem to be full of blood (like when jilqing) except at this full, edged hard.

Opinions?