Can bends correct uneven chambers

I have a few questions about bends, how they work and what you can do with them.

1.) When your doing a bend is it the inside or outside chamber that is being effected? Let’s we are looking down at our dicks and you bend it so the head is pointing to the left. Is the right chamber getting the expansion from the stretch or is the inner chamber getting the expansion from the bend?

2.) I’m assuming that bends are mainly good for girth gains since there isn’t any tension being put on the ligs right?

3.) I feel that my chambers are slightly a different size. I was thinking that if I did bends only to one side that it would even them out. Do you think this is possible?

Thanks for all the help ahead of time guys. If you have any other ideas for evening out the chambers, please let me know.

1) I’m not exactly sure but I think you’re bending the tunica which is the inside.

2) No the exercise doesn’t affect ligaments.

3) Are you saying because of uneven chambers your dick curves in a certain direction when erect? I know people have fixed or helped it by jelqing against the bend. You could try a combination and I would definitely think if you’re doing bends to effect the smaller chamber only in time it should equal out and reduce/eliminate the bend in your dick if that’s your problem.

Have you tried clamping? I’m not entirely sure but I would think if you clamped over time it would just even up naturally. Oh and did you have the ‘uneven chambers’ Pre-PE or after?

I tend to believe that, instead being one of the CC smaller than the other, it is the Tunica Albuginea being a bit shorter on a side (it can actually compress one of the CC, so it wouldn’t be wrong saying the former).

So I think fulcrum stretches/hanging or an extender would be a better option to correct a curve.

Anyway, don’t be too concerned by curves, guys, if they aren’t so severe they are good: you can hit the g-spot in some positions where a perfectly straigth couldn’t.

My dick doesn’t have a curve it’s just a little uneven. If you were to divide it exactly in half the left side is wider than the right.

I’ve done some clamping but I’ve taken a break from it for a bit.

So should I bend to the right or left?

You should put the fulcrum under the wider side.

So if the right side needs to be wider to match the left I should bend it to the right?

Err.. no, to the left. If you bend to the left, the right side (outer of the curv arch) is stretched more, right ? Once the right side becomes longer, right CC can expand more. It will not happen overnight, anyway.

Ok cool. That’s what I thought. I’ll add it into my routine and see how it goes.

Thanks!

No problem. Let us know.

I have the same problem: curve in mid-shaft to the left when I erect! :S

Like you, my right tunnel (cc) seam to be more big and developed and he push the head to a curve to the left. I newbie but I think the “V” stretch or forced curve to opposite side (to the right, with + or - 50% erect) can develop the left tunnel. I practice this technique exclusively for the left tunnel for the moment.

I try another technique with a grip of the head and a OK grip of the base of the shaft (like a clamp).. I squeeze my dick to the right to force the blood to contain in the left side of my dick (kegel can help). The but is growing my left tunnel for egal the right side and equilibrating the two tunnel (cc)..

But I repeat, I am newbie.. It’s all a experimental technique for curve correction! :P I wish heal my “curve” one day! ;)

Sorry for my bad English, I am french Canadian and my English vocabulary is limited! ;)