Removing the threads of Aristo/TGK?

Blame it on Thunder, I was following his lead. TGK is it. :)

Very well: ThunderSS, this is all your fault.

While we’re assigning blame, I’d also like to blame you for my nonfat, double-double, caramel, moccachinno, (with extra foam), being so damn hot that I burned my tongue while exiting the coffee shop drive through, rolling my Jeep over the curb, and chewing up a freshly planted juniper tree.

GM

Sue them for physical, emotional and sex life damage GM.

Sorry Alice, I get in too big of a hurry at times.

I’m not certain what the problem is. The hose clamps shown in the above link are the standard kind; I’ve never seen any other kind here in the US or elsewhere. They just come in different sizes. I have no problems with mine; in particular, I have no problem with my wrap messing up. I get an erection. Then I wrap at the base with an Ace bandage, about four or five layers. Then I stick the clamp on and tighten it against the wrap just a bit. Then I push the wrap and the clamp as far down my shaft as I can. And then I tighten the clamp down fully.

As I said, with much fewer gashes, I can’t put it on with a full erection ‘cause it wont fit. I have to put it on when I’m flaccid and then then gain an erection.
So I need the type of hose clamp that I could put on a hard penis. :)

Forgive me; I must be slow these days, but I still don’t fully grasp your problem. Here in the US, hose clamps come in different sizes, and even the largest ones can be tightened down very far. I’m 5.6” EG mid shaft, and 5.9” right near the base of my shaft. When the hose clamps I have are fully open, they are 2.75” in diameter. I never have them fully open when I put them on, and I put them on when my dick is erect. Like I said, I wrap with an Ace bandage about five layers or so around. I have no problem getting the hose clamp on my erect dick with this wrap. I could even use a lot more wrap if I wanted. Unless your dick is extremely thick to begin with (in which case, I’d suggest that you don’t try to make it thicker!), and/or your hose clamp is too small, and/or you are using a wrap that is too thick, you shouldn’t have any problem.

Also, I don’t understand what you mean by fewer “gashes.” Do you mean the slots in the hose clamp that are used to ratchet it open or closed? If so, it should not matter at all how many “gashes” it has; and I suspect that they are all the same in this respect.

“Here in the US, hose clamps come in different sizes, and even the largest ones can be tightened down very far”
There you have it!

The ones being sold here can only be tensed a few steps. I need hose clamps from the U.S (or any other country that has ‘em). I want to be able to put it on when I have an erection, and tighten it as much as possible.

Thanks for your understanding so far though ;) .

Gotch ya! You’ll just have to plan a trip to the US to stock up on hose clamps!

:D