Replacement Penimaster original base, even a 3D print, anyone done it?

I finally broke the penimaster base on my unit, I knew it was a weak point on the unit, I’ve had it for years and years, one of the original models, it’s not even the pro - but it has exactly the same arms.
Note the small, almost pill like circular / cylindrical base mount which can rotate up and down on an axis.

I imagine there’s a reasonable portion of nerdy people here who have maybe encountered the same thing, has anyone found a solution which isn’t super expensive? I could probably use a high end glue like araldite but I imagine it would eventually break again.

Thanks for any help. Hope I can post a pic without issue.

Hi, I did a a replacement for my 4x labs extender. The problem I see is that the penis master circular holes are smaller, perhaps we can modify this part to fit.

Contact PM. When mine broke, they sent a replacement.

To be fair I purchased mine near a decade ago! (mind you, the use has been quite low, I’ve been pretty bad at PE discipline)
Do you think they’d still look after me?
Furthermore, based on the look of the base, it looks as if the circular mount points at the base are actually molded in to it? I don’t think I can just clip in my existing arms, or did they provide you an entire base with spring loaded arms?

Thanks.

Send them an email. Send them a picture. What have you got to lose? Don’t expect a free replacement. Just be happy with any discount if they offer.

I’ll give that a try, I’d just like to keep it cheap. From a materials and design perspective, the thing should be $10 or $15 but knowing the internet and devices for penis enlargement, it’ll be $98