Silicone Sleeves

Hey Guys,
I suffer from turteling after every Jelqing session. In just about 5 min it goes from a nice hanging to lesser than a playmobil. I think this is holding up my gains.
I tried wrapping with a simple gauze bandage but it cut blood circulation off so didn’t worked.

Should I invest in a Silicon Sleeve ? 2pcs/set Soft Tpr Silicone Sleeve For Penis Pump Vacuum Cup Penis Pump Seals Penis Enlarger Sleeve Penis Extender - Pumps & Enlargers - AliExpress <- here is a link for the cheapest I could find in the web.

Stats
BPEL: 5.6” // 14cm
BPFL: 3.2” // 8cm
Flaccid Girth : 3.4” // 8,5cm

If you were cutting circulation with the bandage/tension wrap, then you just put it on way too tight. I wear a tension wrap almost daily and I’ve only had issues once because I wore it for too long.

Here is a link to my thread showing my tension wrap.

Soonerbombs Road To Self Satisfaction

Thanks for the reply and I read your journey post. Nice story.
I will try wrapping again. Starting erect or semi, because flaccid it constrain blood circulation.

Using a strap wrap you will be able to control more effective the pressure applied. Those sleeves are pretty tight on the first weeks, but get loose in no time, requiring something else to promote any further pressure.

If you are uncircumcised it is most likely to happen some glans slippage, where the glans will be getting sucked inside the strap or the sleeve. I’ve had several encounters with this problem and the key is to find a way to pin the glans in place.

Not sure how it will be if you are cut.

I’m sure someone has beat me to this, but I decided to go down the route of making my own sleeves , I made a ‘cast’ in 3d software/3d printer and then I use 2 part skin safe silicone to pour in, leave it to dry and away you go. The benefit I found of this is that I could make thinner/thicker tubes depending on my needs. Also made a cast for a tip sleeve and an adapter so use the phallsosan bell with the jes extender. I think I paid about £40 for the silicone and I’ve made a whole bunch of fairly thick sleeves, as well as other non related objects and I still have a bout a 3rd or the silicone left. I would guess this is the cheapest way to go about it, providing you have a 3d printer or a friend who has one.