Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

STATIC extenders(extender without springs)

123

STATIC extenders(extender without springs)

Does anybody here got any gains with a static extender? ( the ones that has no springs)
I was reading the big thread the other day from a person that experimented by making his own static stretcher and he said he gained.

Anyone else please?

That’s an interesting idea.

I suspect some of the benefit of water pumping over air pumping has to do with the more static force exerted by water, since it has less ability to expand and contract than air.

There seems to be a similar pattern with static and dynamic air pumping. It seems to be easier to reach a certain size in the tube with static pumping. Though I don’t know if size in the tube necessarily correlates with penis growth. There seem to still be subtle unknowns about pumping to produce gains.


Starting: 7"bplx5.2" 2017 (shrunk from disuse)(originally 8"bplx4.5", gained to 9"bplx6")

Current: 9.0"bplx6.125" 2020

Goal: 11.5"bplx7" 2021.

Originally Posted by Pe_is_an_art
Does anybody here got any gains with a static extender? ( the ones that has no springs)
I was reading the big thread the other day from a person that experimented by making his own static stretcher and he said he gained.

Anyone else please?

If extending I would go with springs. It’s more efficient. On a good day your cock should relax into the initial tension setting within a short amount of time, the springs will aid in this process allowing for additional extension in between tension adjustments. Add heat and one will increase this efficiency.

If it’s an option, I would go for the piston design, although I am sure gains are still possible with a static system.

Others will also chime in here.


Once upon a time (2015): 6.40” x 4.50”

Today: 7.25” x 5.00”, Thunder Cocks Unite!

I think we can...Little Engine’s Climb

I am curious if some members in here gained with static extenders.

Please if you have,then take a moment and post here some infos like how much you gained and what routine you were/are folowing.

LittleEngine this thread is not about me deciding what type of extender to buy.
I already have 2 spring load extenders . The PM and the Male Edge.
This thread is about finding out from members results if extenders without springs are able to deliver any gains and if they are better than the spring extenders.

I gained for the 1st time in my life by using extenders with 400-500grams of tension.
In just 260h (4h/day on average and 5-6 days/week) I gained 0,5cm.
In the past I had done extensively Manual stretching and jelqing with zero gains.

After this gain with the little tension I upped the tenion to 750 and then to 900 and then to 1200 grams for additional 1000h and I had zero gains.
This proves that ONLY low tensions are working. (For me at least).

And this is why I am asking if people have gained with static extenders that infact are stetching the penis with zero tension.
If you use the spring extenders to the maximum length that creates zero tenion then its like extending with an extender without springs in a comfy length.


Last edited by Pe_is_an_art : 04-28-2020 at .

When I was starting getting frustrated about having extended for so many additional hours without even 1mm gain … I started reading EVERY thread from extender users that were not gaining.
The majority of these users they were using a big tension that was NOT providing them a comfortable extending campain experience.
No matter they were doing 9h/day everyday or using some rest days… they were simply NOT gaining.

The same happend to me… at the 400-500grams my extending experience was comfy and I was gaining and when I went to bigger tensions the experience was not so comfy and I did NOT gained anything for 1000 hours at this not so comfy campain.

The extender manufactures have no clue about what is the optimum tension for growth.
Every manufacture is saying different things on teh matter of intensity and volume and frequency.

Also most of ppl thinks that the more hours per day the better…. but in my opinion thats not the case at all.
If you are doing a lot of hours per day you are ending up with the same bad Pis like when doing more intesity.
The tissues are getting harder and they are not reaching the MFSL fast as was with less hours/day.
In some ppl like myself the MFSL is also reducing dramaticaly with bigger intensity and bigger volume.

I truly believe that the holy grail of length gains for every person is extending at very low tensions (0 to 500) for about 6h per day.
When using more tension and more hours the gains seems to slow down or even stop.
Also in my experience 2 rest days per week is vital even with extending.
Every day with no rest days at all(Yes I tried that )… is also making the tisuues become harder and the penis becomes sick so to speak.
On these rest days the penis gets the chance to recover and keep its health so that is ready for more productive extending.


Last edited by Pe_is_an_art : 04-28-2020 at .

Hey Guys, I’m interested in this static extender but I’m unfamiliar with it. Are you by any chance referencing the slider extenders?

Originally Posted by PrnStrWannabe
Are you by any chance referencing the slider extenders?

yes

Originally Posted by Pe_is_an_art
yes

I’ve been interested in them for a while now and have considered purchasing one. However, I think LeLuv is the only company that currently makes one. The problem I have with regular extenders is that I can’t properly extend past my BPEL when extending. There always seems to be an issue with the extender rods and myself and slipping out of it. I definitely would like to try one out.

Slipping out of the extender is just a matter of wrong technique on your side and not a problem with the extender.
If you use a silicon sleeve below the glans and you balloon the glans and immediately strap , you will have zero slippage.

Also being able to extending past or below the BPEL is not something that you decide… its a matter of tissues stretchability from your nature.
The more hours you are extending (with LOW tension) the more stretchable you will be becoming.

In my case my MFSL had become +2 cm from my BPEL from the lots of extending hours…. It didn t make any difference in the matter of gains.
I had gains only when I was extending with lower tension and my dick with that tension was close to my BPEL.


Last edited by Pe_is_an_art : 04-28-2020 at .

Originally Posted by Pe_is_an_art
Slipping out of the extender is just a matter of wrong technique on your side and not a problem with the extender.
If you use a silicon sleeve below the glans and you balloon the glans and immediately strap , you will have zero slippage.

Also being able to extending past or below the BPEL is not something that you decide… its a matter of tissues stretchability from your nature.
The more hours you are extending (with LOW tension) the more stretchable you will be becoming.

In my case my MFSL had become +2 cm from my BPEL from the lots of extending hours…. It didn t make any difference in the matter of gains.
I had gains only when I was extending with lower tension and my dick with that tension was close to my BPEL.

If I went say 1/4 over my Erect length or at least half, how long should I stay at that length until I move up again? I know everyone’s body is different, I’m saying does someone wait two weeks? Three? A month? This is the same question I gave the last person who told me that if I want to see length gains I need to go past BPEL. Also, just to ask, I don’t know what you meant by ballooning. Can you explain?

Originally Posted by Pe_is_an_art
Does anybody here got any gains with a static extender? ( the ones that has no springs)
I was reading the big thread the other day from a person that experimented by making his own static stretcher and he said he gained.

Anyone else please?

Hello Pe artist,

It works really well if it is operated properly. The static extender allows the user benefit from stress relaxation phenomena .
There the tissue is stretched to a certain level and kept there for maybe 10 minutes until it relaxes . The the stretch is reloaded and checked after 10 minutes if it has relaxed again.

You need a load indicator though. Fishing scale works just fine as one. You stretch the thing to a certain load and fix the lenght of the rods. After every 10 minutes you reload to same load and fix the rod length again.


START 18/13.15 cm Jul 24th 18 (7.09/5.18") NOW 22.5/15.2 cm Fer 12th 20 (8.86/5.98") GOAL 8.5"/ 6"

When connective tissue is stretched within therapeutic temperatures ranging 102 to 110 F (38.9- 43.3 C), the amount of structural weakening produced by a given amount of tissue elongation varies inversely with the temperature. This is apparently related to the progressive increase in the viscous flow properties of the collagenous tissue when it is heated. (Warren et al (1971,1976)

Originally Posted by Kyrpa
Hello Pe artist,

It works really well if it is operated properly. The static extender allows the user benefit from stress relaxation phenomena .
There the tissue is stretched to a certain level and kept there for maybe 10 minutes until it relaxes . The the stretch is reloaded and checked after 10 minutes if it has relaxed again.

You need a load indicator though. Fishing scale works just fine as one. You stretch the thing to a certain load and fix the lenght of the rods. After every 10 minutes you reload to same load and fix the rod length again.

Thanks for the reply.
I have a few questions.

1) Why is the fishing scale needed and how is the use of it with the slider extender…?
I know that using a fishing scale for manual stretching would be a good idea in order to know with what tension you are performing every stretch… but fishing scale and slider extender?? why and how?

2) How much did you gain with the slider extender and in how much time and how many hours per day of usage?

3) If the penis has reached to the MFSL in the extender (after many minutes bt readjasting the screws) isn t it dangerous to stand up from a sitted postion?
Because you do not have the springs to absorb the rapid changing of penis length by changing body positions

Originally Posted by Pe_is_an_art
Thanks for the reply.
I have a few questions.

1) Why is the fishing scale needed and how is the use of it with the slider extender…?
I know that using a fishing scale for manual stretching would be a good idea in order to know with what tension you are performing every stretch… but fishing scale and slider extender?? why and how?

2) How much did you gain with the slider extender and in how much time and how many hours per day of usage?

3) If the penis has reached to the MFSL in the extender (after many minutes bt readjasting the screws) isn t it dangerous to stand up from a sitted postion?
Because you do not have the springs to absorb the rapid changing of penis length by changing body positions

1. With a spring extender you know the load by the compression of the springs. With static one you would still need it for keeping the loading in right range.
If you only adjust it by length the loading can be either too much or too low. You just hook the scale on the slider , stretch for a certain load on the scale and lock the rods.
If you have springs on your extender for setting the load that is another thing.
Relying only for adjusting rods alone and trusting how you feel is not very sophisticated way IMO.

2. I am afraid this one I have to pass as I have took that much different road than being in the extender alone.

3. As you predicted the usage of the fixed length extender is not a mobile assembly . You would need to stay put until done.


START 18/13.15 cm Jul 24th 18 (7.09/5.18") NOW 22.5/15.2 cm Fer 12th 20 (8.86/5.98") GOAL 8.5"/ 6"

When connective tissue is stretched within therapeutic temperatures ranging 102 to 110 F (38.9- 43.3 C), the amount of structural weakening produced by a given amount of tissue elongation varies inversely with the temperature. This is apparently related to the progressive increase in the viscous flow properties of the collagenous tissue when it is heated. (Warren et al (1971,1976)

Top
123
Similar Threads 
ThreadStarterForumRepliesLast Post
Static heavy stretcher and hangingpoint1Penis Hangers1105-28-2008 03:22 AM

All times are GMT. The time now is 09:13 PM.