Easy hanger ADS

All you need is:
1 Cable clamp .50 cents
1 roll first aid non stick tape $3
10” Industrial Velcro $9 for the roll
1 Harbringer wrist strap $10 for a set
Small bungee cords $4.99
Medium size dog collar. $3.49

Cut wrist strap about 3” from loop then cut in half. Melt a hole (solder gun) in the end of both strap sides.
Put hook in hole and squeeze shut with pliers.
Open hose clamp completely and put it through the loop and put it back together.
Adjust medium dog collar to fit right below the knee.
Put NON stick tape right below the head then wrap with the velcro.
Place hose clamp right under head on velcro and tighten only to the point it will not slip off. Either hook the bungee to the dog collar for an ADS or through a ?lb plate for a hang.
Grow

Hose clamp under the head? Is that so crazy as I am thinking? Upload an image of this thing in use please.

Above the head. My bad. Pre corona from the shaft.

Here is a picture of it.

Ouch? Is the velcro a stable enough solution?

Check out the original Bib hanger design. That added to the wench mouse pads and/or a very good wrap could produce a comfortable hanger capable of high weights.

The first aid tape makes it comfortable and of course I put the soft side of the velcro on the inside.. Not into S&M hanging.

It looks a good idea if you think your glans is an unnecessary part of your penis.

Actually I have no fear of losing my glans. It works, it is easy to make, its comfortable. Not trying to force it on anyone. If you think it is dangerous delete the thread.

We don’t delete threads here. (:

Maybe I’m getting the wrong idea, that’s why I asked to post a pic of the device in use. A hose clamp a) can cut; b) put a lot of stress in places where there shouldn’t be any, like dorsal nerve and urethra; c) it’s not easy to remove fast. A minimal improvement could be replacing the hose clamp with a cable clamp, although that wouldn’t be the best hanger either.

This is an ADS, right? Not a hanger?

I would understand the concerns if it were hanger. Well, I would probably understand them if it’s an ADS as well. I’m sure it can be done safely, I just don’t like the idea of a hose clamp around my dick.

Hell, it’s hard enough to justify the Bib grabbing my cock. :)

I recently made an ADS and had to make my own leg strap, never thought of using a dog collar, good idea !
For the few pounds of pull you need for an ADS the hose clamp’s probably safe enough but the sharp edges and the need for a screwdriver would put me off.

How long can you wear it without the need for a break ?

Hanging with a hose clamp? Those hose clamps are sharp. I’m already afraid of this one. With my luck, I’d surely be the first to end up with a serious injury.

I will post a pic later in use. I would now but work might frown upon cock modeling.

Here is a picture of it.

Thanks. Less worse than it sounded. Still I would not advice using that thing.