I’m here. Just back from a business trip
In answer to your post #1 There isn’t a need for any weights when your using a Bungee because the Bungee applies the stress naturally. All you need to do once hooked up from the anchor to the hanger loop is step back until you reach the stress level or weight you want.
Now there are great advantages to Bungee hanging. Not only do you get Straight Out (SO) hanging but it also will give you some great angle stretches when you twist your hips. Normally referred to as Over the Leg (OTL) stretches, if you can move your bracket or anchor to eye level now you have Straight UP (SU) but when you twist your hips from this anchor now you a 45 degree angle stretch from the SU.
Bungee hanging is so flexible and it really focuses on the divide and concur principle that stresses the outer edges of the ligs.
Now if you want to expand upon this Bungee application Tool all you need to do is add fulcrums to the mix from any of the 6 angles above.
This is a great way to bust up ligs that are tough or just need to get moving again after a plateau.
CALIBRATION: What I do is hang the Bungee from a high hook and then I apply predefined weights and measure the length and produce a chart of weights and corresponding measurements.
Depending on the length and strength of your Bungee your calibration chart could be quite different from the one I produce so it probably wouldn’t help to send you my chart.