Is something wrong with my hanger?

Hey,

I just noticed something a couple days ago while hanging. The screws that hold the support rope and S-hook are not in direct alignment of each other. The screw on the left side while hanging is slightly lower than the one on the right. When that is taken into account, I wonder if that was and is a playing factor in why the head of my dick is slightly turned to the left while hanging. What does the PE community think, could someone shed some light on this situation?

By the way, I’m in no way complaining about my BIB Starter. After all, I’ve made some pretty nice gains b/c of it. I’m only asking this question because an inquiring mind would like to know if the hanger was designed purposely like this or not.

Wannabe8x6,

>The screws that hold the support rope and S-hook are not in direct alignment of each other. The screw on the left side while hanging is slightly lower than the one on the right. When that is taken into account, I wonder if that was and is a playing factor in why the head of my dick is slightly turned to the left while hanging. <

No, it is not lower. The left side screw is quite a bit more forward however, by design. If you will notice, the channels alternate from side to side. The closest channel on each side was used for the screws.

This is one of the reasons the strap is used and the S hook is free to move so that it may center the pull.

As far as twisting, even if the left side were lower, it would not cause a twist. The penis and head would have to do that on it’s own.

Bigger