Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

Question About Proper Sleeve Usage With Vacuum Chamber

Question About Proper Sleeve Usage With Vacuum Chamber

I have the Total Man vacuum chamber but I ordered a sleeve that’s too small (my fault.) However, when I fold the sleeve around the base of the vac chamber instead of putting it all the way around the outside I can let it hang over the edges and create a smaller hole that I can squeeze my flaccid penis into, and then after a few pumps I’m able to hang the low weights I’m using (18 ounces) with the vac chamber holding to my mid shaft and no slippage.

My question is: is this safe to do? I’m worried about cutting off circulation, although I’m pretty sure most of the grip is created by the suction as the vac chamber with weights attached will not hold at my mid shaft without pumping first and instead slides down to my glans and eventually off entirely. Can I hang like this for the time being or wait until I get a larger sleeve? I’ve tried folding this smaller sleeve down onto my penis and I was alarmed at how tight it was and removed it immediately.

Sorry, I’m new to all this and I don’t want to be inadvertently compression hanging as I’m planning to wear this for an hour at a time only changing the weights and adding heat. What will the warning signs be if I am cutting off circulation?

I’m struggling to picture what is going on. So can’t really give an answer. Is there discoloration at any point of your penis when hanging? There shouldnt be when vac hanging, at least I never had any.

Post a pic so we can better understand your setup.

Or just order the correct size sleeve and not worry with it.


Initial: 7” BPEL; 6” NBPEL; 5.25” - 5.5” MEG

Current: 7.75” BPEL; 7.25” NBPEL; 8.5” BPFSL; 6.5” MEG; 6”x5” Flaccid.

Goal: Improved/consistent EQ while managing ED. Secondary: maintain current stats.

Top

All times are GMT. The time now is 01:45 PM.