Xeno's Lead Cock Coil

Hey guys, I’ve been very interested in Xeno’s cockcoil (if you haven’t checked it out you should:
Cock Coil ADS ). Its basically a coil made of heavy lead which is very easy to manipulate while still being sturdy.

The problem is; I live in the Netherlands and have not been able to find lead wire beneath the ridiculous cost of 120 euro. Has anyone in Europe been able to find/make it for cheap?

Is there not a non-lead alternative? I’m all for enlargement in creative ways, but I don’t think I want to risk lead poisoning Dr. Grayson Junior.

The wire would be wrapped and one would wear something underneath.
And as far as I can think of, no alternative..
Because what would be as heavy as lead but still have the same pliability?

I believe lead is the only heavy, pliable metal suitable for a cock coil

Oke, I have found a solution.

It is possible to buy from the American version of Amazon. However, many countries, such as mine, will have no easy way of payment (such as Ideal).

What you can do is: buy a giftcard from internet and use the code to buy from Amazon.

Have you checked eBay?

If the seller will ship from their country to yours, eBay converts the currency automatically. Well, at least it works that way for American eBay customers. I got my lead wire and shrink tubing from eBay.

Why not just use any old lead, melt it down and cast it to the shape you want. Lead is simple to work with (if a bit poisonous).

I haven’t actually. Ebay isnt big in the Netherlands.

@Memento
Too much of a hassle. Plus.. I dont have old lead, neither would I want to work with it because of the toxic fumes.

Anyhow.. for future European seekers; buy an Amazon giftcard and you’ll be able to use it on America’s Amazon!

You’d need a mold four to five feet long to cast the wire for a cock coil, and making the pour might take several tries if the lead solidifies before you get the mold filled. The lead pot I use for casting bullets holds more than enough metal, but there’s a fair amount of work involved in moldmaking; I just paid the $8 for a one-pound lead coil and never even considered it.

Flip side, you could cast square wire and make a heavier coil, but it would still be simpler just to wind one coil over another.

For a single cast you could use a dry cement mold. Depends how clean you want the cast but shaving off excess isn’t hard.

I have a coil from stealth that I’d sell to someone if they want it… Just take 50% off whatever stealth is asking for it..

As for the covering, dip it in PlastiDip. They also have it in a spray can version, but I’m not sure you could get it thick enough that way.