A Basic Question

Please forgive me, it may be a stupid question but anyway I couldn’t find a post related to this. How do you release your penis after the session. My pump has a button in front of the nose. When you press the button, it lets the air fill in the tube and penis becomes free. I think most pumps have the same mechanism. As soon as I press it, the outer air suddenly fills into the tube, does it give any damage to penis, or the blood vessels, etc.? Or should I press it very slowly for slow air intake? Any idea?

teoman

I’ve always pumped without a gauge!

Male coupler at end of pump line inserts into female receptacle (FR) on top of cylinder. All I have to do is turn FR counter clockwise to release vacuum.
Then I can pull my dick out easily.

Sometimes I will pump…release vacuum….leave dick in cylinder…tighten FR and create vacuum again….I can do this over and over so I don’t have to take my dick out.

Just my experiences,

OR eon
65 yo
Well Differentiated GayMan

I just tilt mine to the left or right, the seal breaks and I’m out.

Thanks mates, now I have another very basic question. My pump doesn’t have a rubber seal at the base of the tube, and I cannot create a seal against my body, cause some air leaks from the pubic region into the tube. I know it will take time to request from the company to send me a rubber seal etc. So can I find a home made solution to this?

What I do to create a good seal is to make sure there is no hair down there. You could shave, but I like to use magic shave cream. It hasn’t caused me pain or discomfort yet. After that, a little KY around the base should do the trick.

anon1122,

I think you are right and the only remedy to this, mentioned in vacuum pumping 101 post, is shaving the pubic region. I hope it solves the problem.

Anon1122.

I can testify to efficacy of shave cream making a good seal…I’ve been using Gillette shave cream for two years.

I rarely have to trim my bush.

Just my experiences…

OR eon