Baseball Bat and Packing

Hey everyone!

I am very new to this website. Actually, I have researched using this website many times for a few years now but I finally got around to signing up so I have a decently conditioned penis when it comes to pumping and a lot of general knowledge.

My issue though, is that I have a sort of baseball bat shape going on. And no, not because of pumping, just naturally that way. Sadly, I haven’t really kept really good track of my growth either so I can’t say for sure that I have grown any.

But basically, I want to know if its possible to fix my shape issue and how to do it. I’ve always thought that penises with the opposite shape of mine(thick at the base, bit thinner as it goes up) are attractive, so that’s what I want, but if I can’t achieve that, I want to at least thicken the base so that my penis is close to the same thickness all over. And of course, increase length.

One thing that I am currently trying that I read on here is using a type of straw thing inside the pump so that pressure still affects the base as well as the tip. And honestly, it seems like it works a bit. But what I used instead of a straw is more like a rubber tube, just because I know a straw would probably end up getting squished which makes its use meaningless.

When it comes to results, its kind of good and bad. I actually think that using the tube allows my penis to reach further in the tube, but not too much more. During and after pumping, I can tell the base is now getting more pressure action because my penis looks more evenly shaped. But the tube is about 1/4 inch wide so it leaves a weird indent on the bottom of my penis but it goes away pretty fast.

Oh! And I’m uncut. Don’t know if that makes a difference but I assume I would have a thicker base by now if it wasn’t for my glans and skin swelling up and blocking off all the pressure from reaching the base.

So now that I finished with my spiel, is there anything I might be doing wrong? Can improve upon? Any new/better methods?

Not an expert here but a few thoughts as I would follow the same strategy of trying to constrict the bulge while allowing the narrow diameter to expand.

Smaller diameter cylinders is one way but another is to insert a “liner” into the cylinder that will reduce the diameter in a specific area. Of course then you will need to add a short piece of tubing to allow vacuum to bypass the area of the liner. For example, a thin sheet of rubber that lines the cylinder for a few inches about mid-way with some vinyl tubing running lengthwise at the joint of the rubber sheet.

How about another approach: wrap the bulge with elastic tape (coban, vet wrap, etc) then use a cylinder that is big enough to accommodate the added size without sucking in too much scrotum at the base. You might need a seal at the base - there have been discussions here about various seals, donuts, etc. to cushion the base of the cylinder. Another way might be to find a piece of thin tubing (cpvc or pvc or vinyl) that you could wear in the area of the bulge - might be easier than tape - thinnest you can find.

Let us know what works. Good luck.