Bath Mate Pump

I recently purchased a Bath Mate Pump. For those that do not know what it is, it is a water pump that is meant to be used in the bath tub, filled with water and then the water is pumped out via an opening at the top of the cylinder.

So far I have not been able to get a good suction going. Anybody have experiece with this? Any suggestions on how to use it for the best results?

Also the cylinder is quite large. I am only about 4.8” MSEG and have read that cylinder size should be chosen according the girth. Would the larger cylinder affect suction and overall performance of the pump?

Anyone?

What kind of grooming have you done down there? A lot of pubes will get in the way of a good seal.

Do you enter the cylinder with an erection? That helps.

I just shaved everything today so I will give it a try again. Also I am uncut, should I keep the foreskin up or down?

I am also uncut. I normally pump with my foreskin down, I figure that it allows the suction to effect the penis head more. Depending on how long you pump for, you will get fluid build up in your foreskin, if your foreskin is pulled back it will form a ‘donut’ below the head. If your foreskin is not pulled back, it will build up in the foreskin at the tip.

If your tube is to big, you will probably start to suck some of your ball sack into the tube.