Best pump

The perfect cylinder for you is a 9” X 1.75”.

Thanks :)

By the way, do pumpers use infrared lights? I got mine for clamping and thinking about using it with the pump. Would it be useful pr harmful?

I have never used infrared lamps, but I always use heat. I wrap my cylinder with an electric heat pad while I pump. Infrared will work too, but be careful, those things get HOT. :flame:

ditto

I shut it down after 10 minutes, because it gets really hot and I fear the bulb might explode or something. In fact I am a bit worried about using infrared in a clylinder as the glass might have a magnifying effect on the infrared light.

Where is a good place to buy pumps online?

What would be the best tube size for me-6.0x5.0(mid shaft)

B-7974

I bought mine from LA Pump (lapdist.com). For my 7 X 6, I purchased their 10” X 1.75” cylinder set. I packed the tube on my first pump and reordered a 10” X 2”. It works well for me.

At 5” girth, you should be ok with the 1.75” cylinder.

Will this give me permanent gains? How much are they? Will it cause discoloration. Just asking for your experiences. Thanks.

Hello folks,
I don’t post much but I read a ton on this forum just want to share some of my findings of homemade pumps.
Best place to buy any part of a pump is adamandeve.com

1. You can get the rubber sleeves $7.99
2. You can get a cylinder with sleeves for $39
3. Best deal of all which is what I have is there brand pump, includes pump, sleeves, and 7 1/2 by 2 1/2 pump for $59. So after you buy a pump, the cylinder, sleeves, and put it together it’s over $59.

Just my contribution to this threat hope it is helpful.

My base girth is closer to 4.6-4.65 is 1.75 going to be to big then? I measured the width of the thickest part and I was just under 1.6 so I wondering if 1.5 would be too small up top. Also, Do you recommend the starter or deluxe kit? Is the deluxe kit loud? I need something quiet for obvious reasons.

And what the hell is with the those 13 inch girth tubes there selling?