Elliptical/Oval Tubes

I have seen passing discussions on oval/elliptical tubes, but very little in terms of any longer term use/results. How many have seen a benefit from these tubes?

I’ve only had one for a few months and just recently have had the chance to really start using it consistently and early results are in: I get a very even pump and my cock looks more like it normally does just bigger. My cylindrical tube makes me more round and I’m naturally elliptical shaped. My lateral expansion is not as limited with an elliptical, too.

I dove in and ordered the LA Pump elliptical (thick wall) tube. I wondered before whether my cock was round or more oval, and as predicted by the literature, easy ruler measurements confirmed it was oval. So I made the purchase, received today. I bought/sized as recommended (if typically use a 2” buy the 1.75” elliptical, which is around 2.25” wide on the long side). All I can say is the first use is promising! I could really feel the pull to the sides on the CC, and could tell they were targeted by the suction when I took periodic breaks for slow gentle jelqs. Used heat, naturally. I am hopeful I will quickly get to a full packing of this size, with the focus on broadening the CC (for lack of a better description).

After packing my 1.75” round cylinder, I ordered an LAPump 1.75” elliptical cylinder which took about two years before I started to pack it 3/4 of the way up. I then ordered a 2” round cylinder which turned out to be slightly tighter than the 1.75” elliptical. I subsequently ordered a 2.25 “ cylinder which is what I am using now.

I just made my own elliptical tubes. They are fairly easy to make, just heat your round acrylic tube to 135 c(275 f) in an oven and they become malleable enough to put on a vice and shaped as you please.

I made them with roughly 1.28 long/short side ratio. I haven’t tested them enough but initial impressions seem to suggest that they don’t offer any size boosting qualities vs round cylinders. Good point is that its harder to suck your scrotum in but I think as elliptical restricts the area close to the base it causes more edema?

I got some vein on the right side of my base that if i attach the elliptical cylinder wrong it gets sucked in and i start feeling pain. I need to do some more testing. Maybe i should have aimed for 1.15 ratio?

I believe the elliptical shape is supposed to be more in line with the natural shape of one’s penis, rather than “size boosting.”

Post-pump one does not come out of the tube shaped like an unnatural cylinder and the appearance is more natural.

Speculation on my part, I don’t own one, but I am considering purchasing one.

If someone is packing a 1.75” round cylinder would the 1.5” elliptical be a more appropriate size in your opinion?

I agree on downsizing the elliptical tube from 2.25 to 2 if you are around a 6” base to 5.5 mid shaft. I unfortunately missed this thread and feel a little lost in my tube. I did get great results even though. My mid shaft came out 6” for the first time. I might try this for a while but what are your guys thoughts?

I don’t have an elliptical but have been using thickwall’s smallest two stage cock and ball cylinder just for my penis. The opening size is just right for my shaft and the second stage gives enough room for curve.

It’s really great to not have my dick pressing on the top and bottom of the tube. It feels way more comfortable when I have a hard erection.

I used to get temporary discolouration on the top of my glans where it was pressed against the tube. I no longer get this. For other results like size I think it is hard to tell, but it is def more comfortable.