Has anyone ever used a stayer while pumping

You probably need a hard cock ring made out of a hard plastic or one made out of metal for pumping.

What it does is let blood enter the penis chambers and doesn’t allow blood to leave the penis chambers until you remove them. so it will let the penis be engorged with blood in the penis chambers and not that much just to surround the penis chambers by letting the blood enter the penis chambers and not letting it go back out of the penis so you get a bigger and longer penis when pumping.

I use an inner tube now; it works but still lets blood leave the penis because it is elastic and gives some but as soon as I make a hard cock ring made out of a hard substance I will get even better results than what I have been getting.

Right now I average about half an inch longer every month but I will get even better results when I stop using the inner tube and use a cock ring made out of something hard that will not give any and not allow blood to leave the penis chambers.
The more blood that enters my penis chambers and is locked in and can’t escape the bigger and bigger my penis will get

OK made a “stayer” or hard cock ring.

I am planning on using it to night to see how it works and will inform people how it worked and share how I made it

Nelson;

Be sure to release the ring every 30 min. or so to reoxygenate your tissues.

I was planning on taking it off every 20 minutes when I release the vacuum on my pump and maybe do some hand stretches after every vacuum release also

What did you make it out of?

round piece of plastic, velcro cord tie, and tape

I’ve never done it. I use a rubber cock ring that’s slightly too big, and use that in the tube.

Even doing that does a great good at engorging. Also does a great job and blowing out and thrombosing lymph glands, which I have 2 that never went away.

well I tried my hard cock ring but it pinches my penis a lot and I am going to have to make it out of something else but for right now I am going to keep using the inner tube because it works and doesn’t pinch my penis.

The inner tube I use is just big enough to put one finger in and I doubled it up “used two pieces of inner tube at the mouth of my cylinder” it works good I just wanted to see if I could get better results with a hard cock ring but the hard cock ring I made pinches my penis so back to the drawing board

good luck if anyone tries using an inner tube as a cock ring; it works but I had to use two layers of very small inner tube the kind that goes in narrow 10 speed bicycle tires the 27 inch ones.

will right back if I find something else to make my hard cock ring with

OK I made a good Stayer “Cock ring” out of the cardboard thing that electrical tape is wrapped around, Transparent tape, and a velcro cable strap.

It work good and it is easy going on and it is easy taking it off.

If anybody is interested in making one I will scan it and post a picture here so you can make one, and will tell how I made it if you can not tell how I did it by looking at the picture.

Nelson, Thanks a bit of description would help. Does it open completely to take off, and do you put it on when you are completely soft or partly hard?

Thanks

OK her is a picture of my cock ring I made.

Cockring.jpg

Put it on with a limp penis and let the pump get it hard

If you are new to pumping try pumping with out a cock ring a while before using this cock ring.

I just tried this last night, i.e., pumping with a hard rubber cock ring. I like the idea, and it wasn’t uncomfortable at all. The most noticeable initial result is that very little extra skin gets sucked into the tube — minimal turkey neck. (Which also makes the unit look longer in the tube :-) I’d previously been alternating pumping with clamping, which leads to a very long workout on some days. I’m hoping this method combines the two techniques sufficiently to get most of the benefits of each with less time. I also like the idea of leaving the ring on for a while after releasing the pump.

If you’ve read some of my other comments in other threads, I’ve become a big fan of cock rings for PE, and wear one throughout the day for spontaneous ‘clamping’, as well as overnight to catch the morning wood.

I will likely use a CR each time I pump now, and use a cable clamp just a few times a week. Time will tell how effective this strategy is…

A question to westla,avocet8 et al:
Lymph transport in the penis, is that done in the outer skin layers? Because if that is the case, maybe a cock ring would slow down lymph transport, lessen the donut effect?

On the other hand Ulcaster seems to have a different story to tell.

To stop the donut effect use an inner inside the cylinder. What you do is stretch the inner tube over the mouth of the cylinder and it must be long enough to reach to the other end of the cylinder.

That set up works best for Hard cock ring pumping. And it helps make to penis longer and have more girth.

Nelson,

I bought a 27” x 1 1/4” inner tube yesterday. There is no way to stretch a one inch wide piece onto my dick? I cut it down to 1/4” and it was so painful - then I could not get it off. I had to cut it off. Very dangerous.

Is this really what you use?