I Have Problem With Bathmate Hercules

Hi everybody

I am using my bathmate about one months. Generally I like my bathmate and I am combining with stretching and jelqing.

Approximately one week ago I jelqed with too much baby oil, there were much baby oil around my pubic bone area, I used my bathmate but it didn’t suck with hot water but I used with cold water it sucked very well. From that time still now I couldn’t pump when I fill bathmate with hot water but I can pump with cold water.

What I can say is when I use hot water I see oil around plastic suction ring :(

Is there Anyone had this problem before.

Or even I prefer use bathmate with hot water What Will happen if I use it with cold water

Thanks in advance

I did the same thing with mine. I did some jelquing, wiped the oil off the penis and got in the hot tub. It did not seal very well. Just a little bit of oil film on the rubber base of the Bathmate was the cause. I just cleaned the Bathmate and seal off with some Dawn dishwashing detergent and it was fine again. Dawn is a liquid soap that is used for handwashing dishes and is known for its grease cutting properties. Also, I found trimming the hair around the pubic area helped too as it had begun to grow out again. Just be sure you use a mild detergent to wash it and not a severe degreaser like gasoline!

Thanks ectospasm for your reply

I couldn’t Solve my problem with my bathmate. I can not pump with hot water but I can pump with cold water but not all the time, is there Anyone has this sucking problem

Best gains

You could have had a chemical reaction between the oil and the rubber pump/seal where the rubber is being deteriorated by the oil. The bathmate is meant for water use and not for oil.

My bathmate has a foam rubber seal bonded to the solid black rubber at the base. Do you see any deterioration of that seal?

Also the valve at the top of the cylinder may be contaminated and not sealing properly. This is another area to try and flush and clean with soapy water.

In the future I can only recommend you keep oil away from your bathmate.

Gprent; But it is intersesting to pump with cold water, as I unterstanding from this situation is hot water reacting oil. It is best I Cihangir sponge if can.

Best Regards

One other thing to try. Try pumping with your bathmate filled with warm soapy water. That will force the soapy water thru the valve at the top to help clean it out.

Gprent; But it is intersesting to pump with cold water, as I unterstanding from this situation is hot water reacting oil. It is best I Cihangir sponge if can.

Best Regards

I think oily part is on the bottom part which is connecting with my body, Thanks for your idea I Will try them all, do you have any experience pumping with cold water

When oil hits water it spreads out everywhere, so there is an oil film on every surface of your bathmate.

I have no experience pumping with cold water. Why? Because it is COLD! :)

Perhaps your pump seals better with the cold water because the oil residue becomes more viscous and therefore seals better. Your bathmate needs a thorough cleaning inside and out. Pump warm soapy water through it several times.

Yeah, as gprent said, inspect the seal closely for signs of deterioration or tearing. Next, soak it in dishwashing detergent like Dawn for 30 minutes to dissolve all oil. Use a bottle brush to get in between the grooves with the detergent. Rinse thoroughly. Try pumping it with hot water on another body part like your thigh to see if it will seal then. If it pumps well with cold water there is no reason it shouldn’t with hot if there is a seal. Finally contact Bathmate for advice and replacement if all else fails.

Dear Gprent and Ectospasm

Thanks for your Advice I cleaned bathmate, at least I have very clean bathmate :)

I did step by step whatever you Adviced me, at the end I noticed that my pump’s seal is not locking water when I stoped pumping if I use hot water. If I press seal locker back that time I can pump with hot water. So as I understad I have problem with bathmate hercules seal. I solved problem with manuel use for now. Maybe it Will be okay with the time.
I
Thanks

I forgot if these things have a warranty. But the tout their excellent customer service, so I recommend calling them to discuss the issue. At least it would give them some consumer awareness.

From their website:

…We have been selling the Bathmate direct from the manufacturer for over 7 years and work directly with the manufacturer to provide fast service and support for all our customers.

When you purchase from Bathmate Shop US, you get fast discreet service, excellent support as well as:

…If you should have any issues with your order you can contact our support department by emailing: support@bathmateshop.us.

I bought from sexshop in Turkey, the seller said me ir is orijinal but I don’t know What I have to do,

May ı ask you a question, is there any way to confirmaton by the barcode Etc.

Thanks in advance

Thanks to this thread I took my Bathmate out of long term storage so I could refresh my memory with it as I answered these questions.

Thanks to that I put it in my shower and used it this morning for the first time in over 5 years. Lots of good news. First it worked perfectly with no leaks and held pressure so the rubber parts had not gone bad with age. Second I was able to stay in control and not go overboard with pressure like I was prone to do in the past. I used enough pressure so the Bathmate would stay on while I was standing taking my shower and after 10 minutes or so got great expansion with no trauma. Later today I will do my regular 30 minute air pump session so will look for any changes to my normal result.

I am going to continue using the Bathmate in the shower and do my best not to go overboard this time. :up: :)