make comfortable seal for pump? Do this.

I guess it doesn’t matter where you buy the acrylic tube, I got mine from a plastic supplier (thick walled) for aprox $20.00, 1 3/4 or 2x12 same price.

Then I took a hand held butane torch, and heated the end of the tube, concentrating on the very end of the tube, as it heated I took a pair of pliers and gently bent a 3/4” flange.

This left a couple small cracks in the flange, 1/8x1/16, which I filled with glue, it works perfect and the seal is very comfortable.

Now I vacuum with aprox 5lb vacuum for 10 min, then raise it too 7, and then stretch the ligs by pushing down on the end of the tube closest too your body, push down and hold for 30-60 sec, then push to the left, right, and pull up also. Push the tube towards the body to increase the seal if you think you might loose your vacuum.

I pasted another post below for further explanation:

“STRETCH / While Erect” while in a skinny tube.

My reason?

I am older and having erections on demand may take some work, so I was thinking, why not induce an erection, with a skinny tube (1 3/4 x12”) and pump to about 7 (vacuum), so as to get a nice erection.

Then, push in (against the body) and down (toward the floor), I really feel a good lig stretch.
Also pull straight out while still in the tube.

I can do this during the day and also do my PC Kregal exercises at the same time, this kills two moves, included in my workout so I can finish off in a hot tub of water at home in the evening, allowing me to get the routine done while bathing in about 35 minutes.

What do you guys think…..*Reference for my thoughts below from med web site:

*The suspensory ligament dictates penis length; if the ligament stays the same length so does the penis.

Think of the suspensory ligament in the penis as a very tough, tight rubber band. It is attached to the pubic bone and the erectile chambers of the penis. Pulling out on a flaccid penis directly away from the body, like most enlargement programs recommend, does not put enough tension on the ligament to cause it to lengthen. What you want to do is create tension on the ligament using leverage by keeping the penis fully erect.

I got most all of my length gains by getting hard as a rock and pushing my weiner down and holding it between my legs while laying down. Lig burn wowee!

My method of flaring the acrylic tube is to hold it over a electric stove element which is turned on high. Try to heat only the first one inch.Use a wooden broom handle to start the flaring outwards then just reheat and push the heated surface downwards onto a flat surface.It will automatically flare outwards,and gives a good seal.I have made several with no problems ,and only takes ten minuets.

Hey Bigplug,

I have thought of that stretch before but I thought it was more dangerous than other exercises. Am I misinformed? How well does it work?

Not sure how dangerous it is if you’re careful, as you should always be in PE. I’ve never had a problem with it, though.

myeight,

Got 12” x 2”I.D. x .125”wall acrylic pipe from a local plastics retailer for $6 and flared as you suggest with no problem. Had an old tee-ball bat from which i cut 1.5” of barrel, sanded off paint which made it exactly right size and epoxied it into acrylic pipe. Drilled a hole in wood plug into which i threaded a hex pipe thread x hose barb tubing fitting using epoxy when screwing into the wood. As a finishing touch, dipped top 2” in some black plastic i have for pliers handles and other tools. Works and looks great at a cost of $8.

Congratulations! A job well done.