Male connector problem

I recently purchased a mity vac break bleeder system from harbor freights, but I’ve run into a problem. I’m using a LAPdist cylinder and the male connector that came with it is too small for the tubing that came with the MV. I’ve unfortunately connected the tubing to the pump already and it’s pretty tough to pull off. Can I superglue the connector in the tube, or will that not give me an effective vacuum system? Anyone know if I buy a large male connector to fit the tube if it will fit the cylinder? Thanks a lot!

Go to Home Depot and buy the correct size tubing for the male connector. In my Home Depot, the tubing is located on the same aisle as the outdoor irrigation supplies.

Or, go to McMaster and Carr and search for part no. 51545k68.

If I read the problem correctly, the lapdist connectors should be perfectly ok, it is just the tubing that is not fitting properly. I am sure he can find the tubing locally and just bring the male connector with him to make sure to get the correct size tubing.

Works for me.

The Home Depots in my area they carry the tubing in the plumbing department, so check both areas.

Tropical fish stores/departments also sell tubing.

Got what needed at home depot. Thanks guys.