Modded my LeLuv pump - best of both worlds?

If I understand correctly, using a smaller cylinder is better for length because if the penis is packed against the outer wall of the cylinder, it has nowhere to go but forward (lengthening) as the pressure is applied, correct?

And if girth is the goal, go for a wider cylinder that your penis won’t pack, also correct?

My base girth is about 6.5” and my girth near the glans is maybe 5.75”. (I’m more of a “cone” than “baseball bat”)

So I bought the 2.25” cylinder to accommodate 6.25” overall girth which I thought would be fine for my base, right? Problem is, when using KY to get a good seal, my smaller ball wants to get sucked up into it. So I’m thinking I should have bought the smaller 2” cylinder.

So I did this… I got a piece of PVC which is about 2.5” long with an OD of about 2.25” and an ID of about 2”. I wrapped some tape around it and it fits snugly inside the LeLuv cylinder and seals just fine. No glue needed. It’s essentially a “sleeve” at the bottom inside the cylinder.

So now I have the best of both worlds…. the bottom 2.5” length of my penis is packing the 2” diameter PVC sleeve, giving more length there where I’m already girthy. And the remaining 5+ inches above the sleeve are out in the open 2.25” diameter part of the cylinder, helping with girth there.

Best of both worlds?

Sounds interesting. Keep us posted on how well it works for you.

Sounds neat. I modded a cylinder to lengthen it by adding a same-sized ABS (plastic) plumbing pipe. It goes at the very bottom, end to end. I sealed the gap with plumber’s putty and, on the outside, lots of electrical tape.

But sounds like you have one inside of the other or…something? I can’t picture it. Can you add an image (product only, no dick)? I’m curious.

Yes, it’s one tube inside the other. The clear LeLuv tube has an *inner diameter* of 2.25” and the little pvc tube has an *outer diameter* of about slightly less than 2.25” (so it fits inside the other)

But it doesn’t run the whole length of the clear tube, it’s just at the bottom 2.5” so it only wraps around the penis base area or so. (the little pvc tube is 2.5” long)

This post got me thinking what if instead of PVC, I could use those silicone sleeves that came with vachanger. So I wrapped it around the tube and the sleeve really needs to be lubed up well to get my penis inside. It really helps to seal air. I tested it with water pumping and the sleeve makes it easier not to spill water and helps to seal water inside, even if I let go of vacuum.

Plus no way my balls are getting sucked in, no matter how big the tube is.

The ridge inside doesn’t chafe your shaft? Or do you have some way of protecting against it?

I took a file/sandpaper and made the edges of the pvc insert all smooth. There’s no problems with chaffing.