Narrow Cylnder Better Length Gains?

Titleist, fair enough, I got into dynamic pumping mainly to improve EQ and it does help there. I have got good girth gains from it but attribute most of my length gains from extending.

Regards

Fred

How quiclly can the mr fantastic change vacuum and is it pleasurable?

Titleist,

You say you attribute your length gains to hours of marathon pumping. Can the vacuum pumping for that long a duration cause blisters and have you ever gotten any blisters?

I would like to try this someday but even right now I’m having a hard time keeping an erection in the bathmate after my hanging routine for even just 20 minutes. I am about to try pumping before hanging to see if that helps.

If my main focus is length(although need girth too), would you recommend I should continue hanging, switch to pumping in a narrow cylinder or incorporate both into my routine?

The rate it changes vacuum depends on how you set the pump speed and to what extent you open the leak valve, It works by pumping up to the max vac settting at which point the pump stops until it reaches the min setting at which point it starts again. Meanwhile the leak valve determines the time it takes to move between the two. I find I can cycle about every 1 or two mins by running the pump speed very low and using a slow leak rate. It is pleasurable up to a point but not like edging. If that is important you can place a vibrating wand to the outside of the cylinder while you pump and that gives you a bit more sensation. I have done that to ensure erection at the beginning of a pump session. Learnt that trick from Gprent. On the other hand you do not want it to be too pleasurable as it not the intention to cum while pumping. I normally same that up for sex with the wife.

Austfred

What is the fastest rate it can do this?

Yes, you can get blisters from pumping too long, using too much pressure. It’s happened to me before, then I found my sweet spot. I can’t speak to hanging as I’ve never done it. I tend to think hanging and pumping would adversely affect my EQ. Everyone is different. I try and get maximum stretch with minimum force.

You would get the fastest rate by maxing the pump speed and using a fairly large leak rate adjusted so the pump was just able to reach the max vacuum setting with the high pump rate so the vacuum decline part of the cycle was pretty short. Never done it as I do not believe a very short cycle time is not good for PE but I reckon you could get it down to a sec or so if you tried.

Austfred

Can i program the mr fantastic to hold a high vacuum for a minute and cycle to a lower vacuum and hold for five minutes? And to keep doing this?

It won’t do that as far as I know.
Have you seen the new Vacutech electronic pump ?

Replacement for the legendary QS-7?

Not sure about that, it has preset programs, a touch screen, is small and bloody expensive !
Have a look at it.

No. THe Mr Fantastic is not programmable. It works by simply adjusting the pump speed and vacuum leak rate. If you have any further questions about it it might be best to PM me as this discussion is not related to this thread.

Regards
Austfred

Great question Marinera, I think that this is a great discussion. Based on my personal assessment even if I sought length, packing a cylinder is not an absolute requirement. However I did find it beneficial to work in cylinder that was marginally bigger than my current size at the time in question.

I can’t answer the question unfortunately. I hope to see new replies and votes.

I’m beginning to wonder if there is just enough difference in structural composition amongst the penis population to result in a greater tendency towards girth expansion at the expense of lengthening in some people. In other words if the resistance to stretching lengthwise is less then the wall or component strength of the CC, then you will develop length over girth and vice versa. I see this being particularly true with pumping but may apply to other PE techniques. Again, another theoretical maybe.