Originally Posted by FryPup
The cylinder is 3.25 inches wide. I enter the cylinder flaccid. I pump for 20 minutes and bring the pressure to zero every 5 minutes. Then stay at zero for 20 seconds, then pump back up 3-5 HG. After 20 minutes, I get out of the tube and wait about 2 minutes before doing another 20 minute set.
It is impossible for me to get erect when both penis and balls are in the cylinder as there is no stimulation.
When I full package pump, I get as hard as possible to enter the tube, if all goes well (and I don’t drop the pump on my toe or something stupid…) I stay pretty hard and pump from there maintaining pressure for the set.
I get out work up an erection back up, and enjoy that for a bit (I have started clamping it off for a few minutes) then lube back up and go back in, as hard to start as I can.
I will ramp up the pressure slowly getting to -5 in about 5 minutes then staying there till the countdown timer marks 20 minutes.
I did three 20 minutes sets each day this week, no problems.
I would suggest going in hard, and keeping it pressurized. Come out when you release the pressure, work up another erection and go back in.
Pump it up slow. Are you using heat?