Pumping with and without erection

2in diameter and 8in long. My girth is around 5.5 i use the pump for both length and girth.

Hello all. First post here, glad to be here. Been PE’ing on and off for 10 years. Made some decent gains the last 2 months with the use of BM, extender/manual stretching and jelqing. Went from 17-18 cm in 3 months. My goal is 20 cm. I have the same problem, so it seems I can never enter the BM fully erect. At most 85-90%. It’s very frustrating, but I pump anyway. Another question (not my intention to steal the thread) is: is it better to do 3 sets of 5-7 minutes or a full 20 minutes session? I also try to incorporate stretching while wearing the BM. I can feel a very deep stretch this way.

I usually masturbate a little in the shower, get hard, then plop the bathmate on and pump away. Sometimes, I’ve just pumped flaccid too though. Doesn’t seem to make much of a difference for me.

I think 2-3 short sessions is better than single long because of 2 reasons. You can have rest, reduce any injury chance. And you can make it multi-steps, gradual. Basically, each new set you stretch it more and more. But we should be careful with time and pressure, not to overdo that, specially if we split in few sessions.

Now i’m facing another problem. I’m pretty sure i stretched that quite well, but i can’t fill full size each time. It’s hard, but i get additional increase only when very horny or use any type of restriction like ring/clamp or hand grip. It’s like gains (i never had that before) and not gains at the same time. So i guess i need to work with muscle/blood related expansion or erection more than tunica. Maybe i also should try to take break.

In the past I always pumped flaccid. My penis retained water with this. I was told do it erect which I do now & have never had this issue again. In addition I pack the tube much better. In fact it’s about time to move up in cylinder size as I fill it in both girth & length when erect. 8” tube X 5” circumference.

Awsome man, I bought myself a dream cylinder at 10 inches long by 5,9 inches circumference. Perfect for my girth because I only want length. The only place thar sell them I found is thickwall cylinders can highly recommend.

HenrikL

You say the brand name is Dream Cylinder?

I was thinking of moving to 10”x 6”. The size you got sounds fitting for me as I am wanting gains for both length & girth still. Think I’ll need 6” round cause my current is 5” & I’m touching on the sides & back side of the cylinder.

I am certainly moving to a 10” length tube but Would you say stay at 5” or move to 6” round tube?

I always go in soft and let the pump do the rest. It usually takes me a couple minutes of pumping the pressure drops as you start to get hard so you just have to keep increasing the pressure. I get the best results that way. I will pump for about 15 minutes three times each with a 5 minute break in between.

Hehe I meant it was my dream cylinder since it had perfect measurments in girth for easy packing!
The brand is Thickwall Cylinder 1,75” or 48mm it actually is milimetrically correct since it is EU made so it is 1 and 7/8 inches diameter.

So expressed in circumference my Thickwall Cylinder 1,75” is actually 1 and 7/8 or 5,94” circumference by 10 inches long. I bought the flanged thickwall cylinder for extra comfort, its very comfortable.

HenrikL

I kinda thought you meant it was your dream cylinder. I’m laughing my butt off right now.

I’ll look into that Thickwall brand, never heard of it before. I was considering a bathmate but to be honest your basic hand pump has worked very well for me.

I’m going to take my time in choosing cause I figure I’ll be in it for some time.

The only real positive of a bathmate is the convenience factor. You dont need lube, you can bring it anywhere since its just the cylinder and not a cylinder+hose+hand pump. The best one for results is dependant on your goals. If you are less than 8” SFL I really recommend the bathmate Hercules or the new version of the hercules the Hydro7, I do Not recommend the hydromax or hydromax extreme series because they dont seal as well to the body.

^^^^ This..

You gotta really fight with the bathmate sometimes to seal. Damn thing just works whenever it feels like it. Some nights I’ve gotten a great pump. Other nights it just doesn’t seal as well.

I’m using a Vacutec Pulsar at 6.5 PSI pumping SOFT and running each level for 10-25 min with a rice sack for heat and after 2 years am able to PACK a 7.5 X 2.00 Pumptoys tube. I just ordered 2.25 X10 can’t wait to start off with it! Merry Christmas to my cock!

Did you ever try doing it erect over a period of time to see if there was a difference between starting erect starting limp?

I like to start flaccid or a little semi. I pump until I feel it’s as big as it will get, then I pull out, jelq it some and get it fully erect, put it in the tube again and pump it up.