Strap on harness belt to attach pump cylinder

Hi Guys,

Bit of a weird question but I want to get a completely hands free pumping system now that I have an electric pump I would like to attach it using something like this

So that the harness goes over the flange of my 1.75 inch cyclinder and holds it in place so I can pump all day long on a low HG pressure and walk around the house without having to worry about breaking the seal because the harness should hold it close and ineffect fix it in place and the low pressure would keep the seal anyone have any experience with this or any good ideas as to what could work with a 1.75 inch tube?

Thanks

You don’t want to pump all day long. It never works. You just get too much lymph fluid build up resulting in puffiness and a big donut.

With this hg I never get donut can go three hours easily and no donut infact I haven’t had a donut for years, with this electronic breast pump is not strong enough to create a donut

Ok finally figured it out and now here we are getting serious with the pumping

Get one of those granny walkers XD.

I use the rubber bands my physio gave me to tie it to my computer desk.

Do you have a photo of the set up, my dick is not big enough yet to warrant a granny walker, and would hate to deprive an old lady, of that need to having assisted walking :)

I think it will be difficult to attach it at the flange and still maintain suction as so much weight is on the other end. I would try a belt with a pouch to hold the cylinder in and which tightens around your waist. The belt/pouch would need a hole to allow the vac hose and fitting to penetrate and connect.

You’d have to make it or have it made.

Not sure what you plan to do with electric pump and extension cord.

Not sure how comfortable any system for this purpose would be.

Some rope, cord, or string looped around your neck down to the tube would hold your tube at a suitable angle.

To keep it pulled up against your body, run some elastic around your buttocks and attach it to the tube near the base. You could probably make a few turns of the elastic around the tube, then put a layer of rubber bands over it to hold it in place. You might need more than one strip of elastic (found in the sewing section in stores), or maybe one of those thin (4mm?) bungee cords. You can also buy “elastic cord” in various diameters on eBay. You’ll have to have enough tension to keep the tube pulled up against you when you walk, sit, etc.

If you use a small-enough tube, so that you’re essentially packed as you slide in, the tube should stay on by itself. With my old, small tube, it felt like I could have pulled my dick off before the tube would let go. Only useful if you’re not after more girth, though.

Once you find out if it works like you want, and decide where the attachment points need to be, you can discard the rubber bands and epoxy some metal brackets to the tube for attaching the elastic.