Trouble About Cylinder Size And Preasure

Hello Guys

I am pumping around a year and still i didn’t get any parmement results. Only one or half days temprory results.

I have a elipctical cock whichs thickest point is mid shaft and it’s 52x36mm.
I have 4 frohle tubes. 5cm , 5.5cm, 6cm and 8cm. I never used 8cm tube yet. I have electric pump whichs max automatic stop pressure level is -200mbar.

Normally i start under shower 2x5 minutes with bathmate x30. As you know inner diamater 46mm. So i can easily full this tube. Then i pump 15 minutes at 100mbar. Second 20 minutes around 150 mbar. And finally 2x 20minutes around moving 150-200mbar. I am pumping 3-4 days in a week. So 1 day on and 1 day off. I have very very small donut effect after this sessions.

My question is i have tear at frenelum. I am using basitrasin based cream to cure. That cures ache in 2 days but tear never fixes at all.

I think the reason is after 3rd session i stuck in pump and frenelum side can’t strech enough and ache starts again next morning.

I am confused a lot. Moving 8cm for avoid stuck? Size chart complately contradict with this choice. What do you recommend to me ?

Note: I am always wraping beurer hk 25 around the tube.

The thing that concerns me most about what you are doing is continuing to pump with a tear in your frenulum. Have you ever taken a couple of weeks off to see if it will heal? If it is an open wound, I would think it would be causing you a lot of pain problems, plus the risk of infection is always there.

You need to heal! And if youre getting stuck then you need a good lube to prevent that.

It’s not open wound. If I leave a break around a week pain complately gone away.

I didn’t understand what’s wrong with my session or cylinder size. After working couple of months i stuck same reason same problem.

I am using Johnsons baby oil with aloe vera. Maybe is this mistake ?

The baby oil is a good lube. The best I can figure out all of your measurements, you should be able to use your 5.5cm frohle tube without getting stuck.

I remember i saw firstly you wrote 6cm cylinder then edited to 5.5cm.

I can easily full from girth side 5.5cm tube first session. And 3rd session i can full 6cm. I am thinking the reason because of elliptical shape.
So always stucking from girth view side. I am thinking frenelum ache reason is here.
Using 8cm is bad idea? Always pump tube should be slim fit to cock?

No, using the 8cm is not a bad idea. It is a huge jump in size, but if it feels comfortable go ahead and use it.

Have you ever measured your erect girth using a tape measure and if so, what is it?

It’s just that filling a 6cm tube takes a huge girth on the order of 7.4 inches (18.8cm). Sorry to mix units, but inches is what I can relate to.

What is the style of your froehle tubes? Are they for cock only, or are they shaped for cock and balls?

Are you lubing at the base/seal area as well? If I dont then my skin will sometimes get pulled unevenly and feels like it could tear.

My exact size for girth as following below.

Thickest are is mid shaft. It’s 52mm x 36mm full diameter.
With a tailor tape a measured 15cm circular.

My first warmup (100mbar) tube is this.
https://www.ama … /dp/B007RCAGNA/
Because of its very easy to pack from girth side i never go over 125 mbar (5"hg)

My second using 6cm tube is this

This is my 8cm tube which i only used couple of times.

Actually i am using too much lubrication ( Johnsons baby oil with aloe vera) .

One tube 300ml is finishing around a month. Pumping sequence 1on day then 1 off day.

At 3rd and 4th sessions i feel i stucked in pump and a ache of tear at frenelum area. There is tons of lubrication. Maybe it should more ?