Wider Cylinder For Curved Dick Problems

So I just got a LeLuv 2.25” cylinder. I don’t need that much width except for the fact that my dick curves down a little so I need the extra width to get it in. Even with the wider cylinder the top of my shaft rubs against the top a little but it’s fine.

Because the base is wider than my dick I’m getting tissue from around the base sucked in that’s causing some pain.

I tried it at -5 for a few minutes. I started bleeding a tiny bit around my base and stopped.

How can I remedy this situation? I need the wider cylinder for my curved dick but the space at the base is damaging tissue. I don’t know what to do.

You can use a cylinder smaller than your maximum girth, irrespective of a curve. You just go in at 75% erection, or whatever will bend enough to get into the tube.

That’s also how you size a tube if you have an exaggerated ‘baseball bat’ shape.

As an aside, hanging will usually result in a somewhat ‘traffic cone’ shape, which will make it easier to get a seal with the tube.

There are also the Froehle tubes out of Germany, which have a ball pocket.

Have you tried using a liberal amount of coconut oil, on your penis, and in the cylinder as far as you can reach with your fingers? You should also pull down on your testicles while sealing the cylinder to your base, and then once you have a little vacuum applied pull down on them again before applying more vacuum.

I also have a slight downcurve, and I use a 2.25" cylinder with my 6" girth, this works very well for me.

I’m 5.6” girth in the middle only. Do you think I should should get a smaller cylinder? I’d hate to have exchange it.

Thanks. I’ll try that.

It’s just some of the flesh around the base of my penis that’s getting stressed too much.

I think the pump is actually straight inch my curve.