Wrapping for extra length in pump

Sorry basil, I havent seen a cylinder with attached electric pump before. My guidance was for a conventional cylinder-hose-pump system. Good luck.

@Crazyant, thanks but I need something that keeps me tight against the tube, I’m close but I don’t think even a thick condom will work.

@32quarters, no problem, I’ll have a think whats best to do. I’ve never really had much luck with pumping, not as much as with jelqing anyway and I can’t do that any more. I’ll see what I can work out over the next week or so. Thanks for your help though everyone

Why do you want to be tight against the tube don’t you want room for expansion

I tried the electric pump that’s attached to top of the tube only had a chance to try it once I just got it yesterday so not sure how I feel about it. And the tube is 2 3/8 on mine

Hi Rocko, I’ve just measured mine again and its definitely 2 and a quarter inches. In my opening post I explained that I was wondering if I packed the tube width ways and basically stopped any expansion in girth if all he extra blood would force the penis a bit longer. As in if the blood can’t expand the penis width ways it may force it to go a little bigger length ways. I’m after length gains only for now.

So the electric pump seems to just cause pain don’t feel good at all on day 2 since using it and feel like I’m recovering but EQ is still not up to par I think I’m going to pitch it and stick to one that has a gauge. In theory if you pack the sides where else does it have to go but up, so it can possibly aid in length while maintaining your girth. Now I’m no expert but that’s my opinion.

If you are packing the tube with intent to focus on length you need to make sure your shaft is well lubricated so it can slide in the cylinder. If not, you are only working on the glans. Depending on which lube you use, you may need to relube every so often. Added heat is always best, but the heat can dry out the lube.

Yeah I made sure of all that it was the vacuum hard to explain but all I can say is the suction was painful even on low and shutting it off quickly. Would love to see how much vacuum that created even on low and shutting it off quickly but it don’t have a gauge so no way of knowing. About packing it.. I wish lol. Not quite there yet that was in response to basil1492 in a above post. Sorry I should’ve made that last post a reply to his. I’m new to this online stuff and learning my apologies

I don’t think you need to pack the tube. Constricting your girth will force you to go longer. Perhaps follow the wrapping methods of those who hang weights, consider taping, or both. Compress your girth so you can only stretch outwards.

I’ve only tried pumping and jeqling for girth I hear about clamping is this something that would work without negative effects?

Thanks all, I do lube up well and I’m not quite packing the tube. I’ve tried wrapping etc using ace bandage, it just sticks to the sides even with lube. I’m still trying to work something out, a way to temporarily narrow the tube. All I did was cut up a 2l bottle of pop (same length as inside of cylinder), cut down the side and rolled it up, put it in the tube. I did make sure there were no sharp edges. First time I tried it it split the sleeve, I hadnt cut it a bit shorter than the pipe so a bit was sticking out. I cut a bit more off it so when fully inserted into the pipe it was about 1cm from the opening.

I’m not 100% sure because the angle makes a difference (if I lie down a bit lower it looks like it’s hit a higher length etc) but I seemed to get an extra 5mm length at the end of the session. I wasn’t touching the sides all around though so I’m going to roll up another bottle to put inside the last one, see how that goes. As for lube I use silicone friendly stuff at the sleeve but I squirt a little baby oil around the inside of the cylinder, it seems to work well.

One last thing, because you can take the top off this cylinder (the electric motor thing) I have done that before and tipped some warm water in for heat. As long as you keep the tube upright it doesnt suck up water as long as you only fill it halfway. It does seem to get bigger that way and I can get to my max a bit faster but I havent tried it with the bottle inside yet, not sure if it will affect the baby oil.

If you can sew I have a solution. Buy a compression sleeve for your knee, cut it up to the size you need when you sew it back together into a tube shape for your dick. If you sew it the correct way it will expand just a little in girth but allow your dick to lengthen up and out the end of the tube.

I did that with an ankle compression sleeve, have outgrown it in length. Have to buy one for the knee and start over.

Thanks everyone, time to close this now, ended up buying a new tube from thickwall, its a lot better than I had, I’ll see how this goes now over the next few months