Back To The Pump 2.25 Dia. Cylinder
Yesterday was my first day back to pumping, and it was great!
My new 2.25in Diameter assembly came in the mail yesterday, and this set up included a seal cap at the end where you can insert your penis. This was the first time I’ve used the seal cap.
At first, I tried the pump without the cap just to see how my penis would respond to pumping again. The cylinder has a bigger diameter than the 2.0in I was use too using (going for more girth this time). I actually thought I ordered both the 2.0in and the 2.25in that way I can switch between girth and length training.
Anyway, I was hesitant with the seal cap because the opening didn’t look big enough for insertion and I was concerned that blood circulation would be cut off when doing my pumping session as the cells expanded. Needless to say, it was a really tight fit, and my penis got semi-erect while trying to fit it thrift the rubber hole (not pleasant at all).
I had to wait until I was fully flaccid again before trying because it was too much friction against my skin. Even fully flaccid, it was challenging to pull my penis through and I had to work the seal cap down my shaft to get it to the base of my penis. I had to wait again for my unit to get flaccid again before inserting it into the cylinder with the seal on.
One thing I liked about the seal cap is that it kept my penis centered on the middle of the cylinder. It would usually rest against the side when pumping and end up having the skin pulled and swollen. With the cap, as the cells expanded, the rubber expanded with the penis and kept a tight seal and made for a proportioned pump!
I did a 10 minute session at 5 psi. Today I’ll shit for 15 minutes.