Thunder's Place

The big penis and mens' sexual health source, increasing penis size around the world.

SizeDoctor Experiment

SizeDoctor Experiment

Hi all,

I’ve been doing jelqing exercises on and off for years, have bought all sorts of different devices and pills in order to enlarge my member. Nothing really has worked so far, and I gave up for quite a bit. To be fair, I never had the consistency with Jelqing to give it a fair shot, but for sure all pills, vacuum devices (water or air based), and strap extenders did not work for me at all.

What I’d like to do is experiment with the Size Doctor (a vacuum based extender) to see if it has any efficacy on erect bone pressed length. I didn’t pick that brand for any particular reason. If I could of found a phallosan cheaper, I would of gotten that- I just wanted a decent, cheap vacuum extender device. I purchased a reasonably-priced unit from aliexpress (consumer facing side of alibaba, a chinese company akin to Amazon) for ~62 dollars. I took the free shipping which only took about 12 days to arrive at my door step in the North Eastern US from China.

Why did I pick a vacuum based extender?
I keep reading about how they were much more comfortable than the strap based extenders. I bought two previous brands that were strap based and ended up tossing them out after a year since they were impossible to wear for any duration longer than 1 hour, even with wrapping, which was extremely time consuming. Wasted time and money, but I think most of us over the years have wasted time on this pursuit by people looking to profit off our attempts to gain.

Quality of the Unit:
The unit I ordered from aliexpress seems of pretty decent quality for 60 or so dollars. The plastic apparatus at the end of the extender poles where your head is inserted into is quite durable/thick plastic that has an amber tint to it. The components seems a little cheap but definitely do the job. They give you plenty of spare rods which was really nice. You roughly could stretch up to 9-10 inches with all of the extension rods they give you. They also give 6 plastic round apertures (look like donuts, essentially), that go around the rim of the plastic apparatus at the end of the extender. These graduate in diameter from the smallest (1) up to the largest girth opening (6). I cannot compare the quality to whatever "official sites" sell, but I am not spending 300-400 dollars on an extending device. The mark up is insane on these devices. I would guess these devices are all manufactured in China anyways, most likely. The unit I received was from a Korean company, but the box/packaging looks exactly identical to what you will find on the US sites. I used google translate to understand the manual that came with the box in Korean and fumbled for about two hours to learn how to apply it to my unit properly by trial and error.

Comfort of Application:
I personally have found "3" girth ring is relatively snug for my flaccid size and enjoy the more secure feeling while wearing the extender. I tried (6) and worked my way down to (3) for the first few days I’ve been wearing it/adjusting to using it.
It’s definitely required to have water-based lube be applied to the head of your penis as well as underneath the ridge in order to assist in wearing the device, otherwise it becomes painful to remove the device and difficult to apply onto your penis. It’s pretty annoying to remove/add the girth silicon rings to the plastic chamber opening as they’re very taught/snug. This is a good thing however, as it ensures it won’t come off and creates a proper vaccum- still pretty annoying to apply by hand however.

Application onto your penis is a little awkward at first but easier once you get it down. I lube up flaccid along my head/under the ridge (anywhere that comes into contact with the silicon girth holder), and then take the entire extender unit, put my penis head right into the opening of the silicon, and then give 2 or 3 solid pumps with the bulbous pump that creates the vacuum. With the lube, the head will slide right in to fill in for the vacuum that’s created. One annoying thing that takes a little while to get down is once you have your head solidly inside the chamber, removing the pump from the top of device (where the vacuum release value is) is pretty tricky. I usually have to fumble with it 3-4 times to get it right and then seal the vacuum with the metal hanger that holds it closed. This is where the quality of this device kinda sucks, but it’s workable.

Once the device is on, I can wear it for hours and go about doing stuff in my house or just relax/read/watch a movie. This is not a device you can easily wear outside the house. I won’t even attempt it, personally. I’ve seen some videos of people saying you can tuck it up into your pant belt and cover with a longer shirt, but it’s still obvious. There’s a huge bulge going up onto your stomach. So this is not one of those device I’d recommend or even thinking about wearing outside. It’s way too obvious.

Expectations from studies done:
So far I’ve logged about 6-8 hours a day. I haven’t kept absolute track of the hours, but that’s what this log is for. I’d like to make measurements at 1 month intervals with major ‘check ins’ at 3, 6, 9, 12 months to indicate if there’s any progress. I’ll be adding in light jelqing after the stretch sessions for about 10-15 minutes. Heat application/warm up is from a hot shower after the extender is removed. Studies done with strap extenders indicate that penile flaccid length (hanging length) improved around 1-2 inches after 6 months, and stretched length improved by about ~2 inches wearing a strap-based extender for 6 hours a day for 4-6 months.

Best case, flaccid hang improves 2 inches, stretched length improves by 2 inches, BPEL length gains aren’t indicated in these studies, but from other posts from members on this site, I see about 1 inch gains per year or so. That means about a half inch gain at the 6 month mark would be a ‘best case’ scenario to hope for.

Worse case, no gains at all of any kind.

I will most likely make weekly updates and monthly measurements to log progress. Daily hours logged will be kept in a personal note book. Let me know if you guys have any questions, want pictures of the extender unit, or any suggestions for this experiment. Although it’s just a poor study (n=1), hopefully adding a little more data to the pool of the members here will give us better insight into what works and doesn’t.

Starting Stats:
6’ BPEL

Short Term Goals:
7’ BPEL

Long Term Goals:
8’ BPEL

I haven’t measured flaccid or girth, but I will after my stretch session and update with another post as a benchmark. Also of note is that I’ve only had this extender for a week before I wrote this post.

For further reading on the studies I referenced and looked at:
Effect of penile-extender device in increasing penile size in men with shortened penis: preliminary results - PubMed
http://onlineli brary.wiley.com … 10.09647.x/full


Last edited by graccus : 05-14-2016 at .

Last night I wore the size doctor for about 6 hours. I had pretty bad fluid retention due to excessive vacuum pressure, essentially a small “bubble” underneath the ridge of my penis that looked pretty awful. It went away after about an hour. I dry jelqed for 15 minutes, 3 min strokes with the OK grip afterwards to help assist in eliminating the fluid build up.

Today I took it easy on the pressure on the vacuum head to reduce fluid build up as much as possible. I’m aiming for 6 hours, pretty much 2 hour sessions with 15 minutes in-between with a little bit of jelqing to help reduce fluid retention and give my dick a break.

I have a slightly more thick and longer hang on my flaccid so far after only a week of wearing this. Nothing too impressive. Approximately a quarter of an inch or so longer hang I noticed. Have no measured anything else (still aiming for weekly intervals for measurements max).

Another note, after taking the unit off after the total session (6+ hours) my dick turtles for a while, but then returns back to a normal hang after a few hours. Has anyone else experienced this?

Another 6 hours logged today, currently going for 8 hours (last 2 hour session). Way less fluid build up with the 2 hour intervals + jelqing to break it up. Going to continue with that in order to avoid any kind of turkey neck.

Yesterday I missed out totally on any time with the vacuum extender due to work. I got home a bit earlier today and threw it on. It’s a lot easier now to work with- I found that wiggling the unit after pumping the vacuum will cause the stopper at the end of the unit to ‘drop’ and seal the vacuum better. Before I was just pulling the pump off and it would break the seal every time which was extremely annoying. I found with this method I can create a seal easily without having to re-pump several times.

Wearing the unit directly up (as suggested in manual) causes a loss of vacuum for me over time, causing re-pumping during the session. I’ve worn it straight out with my fly down around my house and sort of let the unit poke straight out (benefits of living alone). This causes a nicer ‘stretch’ feeling on my dick and is more comfortable to wear. I haven’t worn this to bed (as in gone to sleep with it), but I’ve worn it in bed straight up and laying on my side while I do some night reading or browsing on my phone. This is relatively comfortable but again, I get a loss of vacuum in the head unit after a while.

I’m sure there’s more quirks to vacuum extenders that I’ll find out over time during usage, but I have most certainly been able to log a lot of hours so far. 72 hours so far, and going for 80 hours tonight in less than 2 weeks (aiming for 6-8 hours a day). I’m going to measure this Sunday (BPEL) since my fat pad is pretty large. I’m also working out and going on a caloric deficit in order to cut down some of my fat. The fat pad really covers up about a whole inch plus of the unit, so it looks a lot smaller than what’s there (depressing). As of my initial measurement erect length without pressing into the fat pad was 4.80’. So about an 1.2’ lost to being a fat ass. My own fault, but that’s why I’m here to fix it.

Any updates brother of the same struggle?

Update on progress

Avirex1987, thanks for checking out my thread.

I’ll attribute this to noob gains but I’ve gotten to 6.25” when I’m rock hard. I’ve been averaging mostly 3-6 hours a day with the device but it’s still a struggle to keep it comfortable. I’ve missed a few days too but haven’t really been jelqing.

I’ll keep wearing it but I have to get creative to see if I can figure out a way to make this device more comfortable. The plastic girth rings are not very comfortable for a long duration, and getting the vacuum pressure right is difficult.

I’ll update again in a week or so if I get more progress, but I’m happy with the quarter inch or so of progress. I think the weight loss will also help with the visual aspect of enlargement.

Hey man a quarter inch is a big deal, congratz! :D Even EQ gains are, in my opinion, gains. You might have technically owned it, but if you didn’t have access to it before then it doesn’t count. Can’t buy a loaf of bread with money stuck behind a locked safe ;) .

Too bad it’s taking you so long to get those gains… Maybe you could look into different methods if this isn’t working for you. Good luck!


February '16: 173 mm BPEL (6.81") 132 mm MEG (5.20")

November '18: 190 mm BPEL (7.48") 137 mm MEG (5.39")

Goal: A sustained 7.7" by 5.8" during intercourse

Hey graccus, how is the SizeDoctor experiment going?

I’ve just started my own experiment with it. It seems more comfortable on my dick skin than a noose extender (as they obviously use friction to grip the shaft skin) but my glans sure is feeling the pump from wearing it!

I have a very spongy glans which can get very large erect and can fill the glans chamber on the device, but can also shrink down a lot when compressed, despite being a good size visually when flaccid. This means it can still slip through the smaller girth rings without a decent vacuum pressure holding it to a larger size (the required lube to apply the device in the first place being the cause of the problem I think). Trouble is, the tight girth rings are then uncomfortable on my shaft! I’m still playing around with the pressures and rings though, and I think my dick is getting more used to it. Just need to make sure I adjust it every hour or so. Bit annoying at work, but I think this device might actually pay off as I can feel a good stretch through the core of my penis with it, which I think was the cause of my plateau so many years ago!

Anyway, it would be interesting to hear how its going for you now, a few months further down the line.


Start: 22 Mar 04: 6.5" BPEL x 4.6" EG & 6" head. As at: 1 Jan 05: 7.5" BPEL x 4.8-4.9" EG & 6.3" head.

Re-re-start!: 6 Feb 17: 6.9" BPEL x 4.9" EG & 5.5" head. As of: 23 Feb 17: 7.0" BPEL x 5.0" EG & 6.0" head.

Ideal: ASAP: 8+" BPEL x 5.5+" EG & 6.5+" head But will continue if the going is good!!

Top

All times are GMT. The time now is 05:58 PM.