Easier Removal Anti-Fluid and Anti-Blister Tape Discovered

Many PE connoisseurs, including myself have found themselves at one point or another in need of anti-fluid or anti-blister tape to protect the glans from blisters that occur while the penis is under vacuum. This could be from many vacuum stretching/ADS devices as well as for pumping.

I experimented with using the 3M micropore tape which is recommended widely in the community. My experience was not pleasant with this tape. I’m not sure if my gland is especially sensitive or not but removal of the tape was unbearable to me. To the point that I would not use my devices for fear of getting blisters and not wanting the difficult removal issues.

I wanted to contribute this discovery to the community, I have been using it for months now with little to no irritation to my glans and it has prevented all blisters adequately. It is the Walgreens brand silicone tape that is seen in the attached picture.

My hope is that this helps someone here with a similar problem associated with the micropore tape!

Do you wrap the entire glans e.g. Like a mummy?

Is it friction-grip? (vs. uses adhesive).

3M micropore tape is best removed by taking a towel and running it under warm water. Use the towel to get the micropore tape wet and massaging it. Repeat this a few times and get water under the micropore. It will take about 1 minute and will come off without issue or pulling.

I do not have any experience with using the silicone tape but you may wish to try using the micropore again using the removal method I described.

I’m using self adhesive bandage wrap, and I can remove it whole, or unwrap it and reuse it pretty easily and pain free.