New method for horses

Hey,

Just wanted to tell people about how I do horses ‘cause I think it’s alot easier than doing it the regular way.

You start out the exact same way as when you do a regular horse: get really hard and grab with an ok grip at the base of your penis. Then, instead of making a really small circle with your other hand and trying to push it over your head, you just put your whole other hand over your head and squeeze with your palm facing down. Your index finger and thumb should make an ok sign right below the head. Then you just hold that there for as long as you want.

I hope that makes sense.

Does anyone else do this?

Hi Mick,

If you want to try a slightly different take on what you’re doing just TWIST YOUR HEAD SLIGHTLY as you are holding your ok grips at the base and also below the glans. You should feel even more pressure being exerted. You can also push the envelope just a little bit more by doing a slow dryjelq with the lower ok grip up towards the ok grip below the glans while twisting slightly.

Be extremely careful newbies! Don’t do this until at least one or two months of training your dick with regular jelqing. Remember that at the beginning less is safer until you really know your body and the stresses it can tolerate.

Peforeal

Yeah lots of people do horses by squeezing the head. Its a good variant and worth bringing up.

Watch out with those horses early on Mick, in the first 2-3 months of PE’ing these kinds of exercises are best avoided, very easy to cause injury and then you find you have something thats incredibly easy to aggravate later on in your PE career.

peforeal: Hey, thanks, but what exactly do you mean by a twist? grabbing the head and turning it to the side? Like a 90 degree rotation?

memento: Thanks for the advice. I’ve actually been PE’ing for about 6 months now though. I’m also not doing the horses right now, I wanna get my length done first, just thought I’d post that. Thanks for the concern though!

Its in the newbie forum though Mick so its good to have a warning somewhere :) (of course peforeal did that but I didn’t see it).

Hey memento,

I guess I’m just used to posting here, didn’t think about that. Next time I’ll put a warning.

Mick,

You asked: “peforeal: Hey, thanks, but what exactly do you mean by a twist? grabbing the head and turning it to the side? Like a 90 degree rotation?”

Yes, that’s what I mean but the twist doesn’t have to be 90 degrees. Just a little turning of the head will force the pressure between your lower and upper ok grips to increase on the shaft area.

Newbies, be careful. This is not for beginners.

Peforeal