Vacuum Pumping Issue

So I know this has been discussed but can’t find a solution for this issue.

So I bought a vacuum pump after using a bathmate for a few years. Wanted to see the difference in expansion. Long story short lived the expansion. Loved the pump and results so did the wife. After about a week the pump cable broke it was a cheaper pump so it was inevitable. Bought another one online same size cylinder has a different rubber seal on the bottom I thought would work better but to my surprise it doesn’t. So at the bottom of my shaft I have Abit of a turkey neck from the bathmate I believe is where it started. So while I enter the tube erect and turn on the vaccuming to create suction as the seal creates no matter how hard I try to hold the cylinder higher up to avoid my turkey neck being sucked in it happens I’ve tried using a cock ring to pull down my sack and the extra skin but it still pulls it in and the only thing that expands is the excess skin at the base no shaft expansion no head expansion. With the other pump this was not the case got excellent all round expansion how can I solve this issue. I spent a good amount on this pump so I’d like to figure it out instead of starting over. Any thoughts ?

PumpToys offers a thick silicone gasket that works well on cylinders with flanged base edges.

I tried to put a thicker silicone cock ring on and it made the silicone base lose the seal. The I guess you could call the rubber seal at the bottoms has a hole that is pretty small like you have to force it even with lube. So I thought this wouldn’t be an issue really at all. I think the pump is just a piece of junk honestly poor purchase I guess on my part. But thank you for advice it’s always appreciated. I bought it because it was virtually hands free turn on the pump it increases gradually over time and if the pressure elevates it goes up as well has an LCD screen that gives time pressure so I liked the idea.

First off lets see if that cylinder is the right size for you. What is your erect base girth measurement and what is the diameter of your cylinder at the opening? Also, do you have a web link that shows the pump you bought?

When packing the tube the scrotum doesn’t tend to get sucked in since there’s no space for it.

I think turkey necks look attractive and add to vaginal stimulation.

The gasket I mentioned is not a cock ring. It fits over a flanged base.

Buy this VelSeal Gasket at Pumptoys.Com

Well the box said it was 1.75 but the one that broke said the same thing but was definitely smaller. The cap I guess we’ll call it that .. Was on the bottom of the cylinder had an opening of the size of a nickel was pretty tight. I wasn’t entering directly into the tube it self. I have a replacement from the other pump I bought so I’m patiently waiting for that.

My base EG is 5.7 inches mid shaft is 5.2 inches all around pre pump or pre routine size is 7.1 x 5.2 inches. I use the x30 for the bathmate. I mean after using it for so long I’d say it is a smidge large but the site said it was the preferred size for me. But isn’t a slightly larger cylinder good for all around gains ? Correct me if I’m wrong I’ll take any pumping knowledge given. I truly believe I need to stop pumping for awhile. I feel as if my dick is more strong than pliable if you know what I’m getting at. I can kegel fully for about 6 seconds or so when at the max pressure that I use don’t usually go over three pumps inside the bathmate. But even in the short lived vaccum pump session I could also kegel a good amount with substantial pressure.