Varying measurements

Hello guys, today when I decided to measure my EG I kept getting different measurements. The lowest measurement was 14.2 cm (5.59 inch) and highest 14.8 cm (5.82 inch). I kept measuring multiple times in hopes of getting a constant measurement but no it kept varying. While measuring my I think EQ was somewhere around 90 - 100% and I was measuring at the same spot all the time. Now I don’t know what should I consider as my current girth.

Has this happened to anybody else?

You answered your own question. Your eq varied and your measurements varied as a result. Happens to everyone. Use the number you registered when you were 100%

I don’t think I’ve ever been able to measure 100% erections.

Too busy inserting them in my wife.

I would say go with the higher number everytime you try. You could average them if you care that much.

I agree with these gentlemen. Your erect girth should be measured at 100% EQ so I would go with what you got at your best. You can also try again later or tomorrow.

I would say my 100% erection is around 75/8”x 61/2” but can’t claim it as measured because my dick shies way from the tape most days.

But the problem is that I am a bad judge of EQ. The thing that worries me is the big gap in the upper and lower measurement. Not really sure what to enter in the log.

Same problem with me. And since I have this downward curve it gets really difficult to measure. When I measure with a ruler my BPEL comes to 6.9 - 7 inch and around 6.4 for NBPEL, but when I measure with a tape without straightening my NBPEL comes up to 7 inches.

My dick always seems to be ruler shy. Every time I go to measure I have a hard time maintaining a 10/10 erection. I always use my maximum measurement but I have to be able to consistently reach that measurement.

i.e. have you been able to measure 5.82” across multiple days and seen that measurement at least 5 times.

Well I am not sure if I got that measurement at least 5 times but it was definately more than once!