Build your own EnlargerStrap

With all of the interest in the enlarger strap, I decided that I would like to try it out for myself. Due to privacy concerns I prefer not to receive PE related material through the mail, so I decided to make my own. After some thought on how to go about it I came up with the idea of using a rubber glove and and old belt. For the connecting piece I used a snap off of an old dog muzzle that I had lying around. Camera bags and backpacks have the same type of snap in connector, as do some of the old belt bags that fasten around your waist. The enlargerstrap website has a template for sizing your purchased strap as well as enough information to make your own. I sewed the bottom of the snap onto my belt. So far it is working out pretty good. I have attached a pic. of the completed unit. Total cost under $3 just buy the cheap rubber gloves for kitchen and household use.

Good work!! I thought of something along these lines but so far I’m gaining fine with only manual PE (very stealthy and no cost) so I never bothered to try it out. Keep us updated on how its working out!! Kudos.

I am clueless how this thing works (the Enlarger strap and it’s imitations). Could someone explain this to me; that is, the mechanics of it? I can’t figure it out from looking at it.

It is used as an ADS. Basically you attach it immediately after hanging and wear it for an extended period. I cannot at this point speak as to the effectiveness of the device as I have not had much experience with it. The belt is attached to your leg either above or below the knee, depending on your length, and the rubber end is wrapped around your penis after wrapping with your preferred wrap. I personally use a 2” Ace bandage, and attach the device with two strips of Velcro. I forgot to mention in my first post that you can either buy the Velcro at a store that sells craft supplies or you can rape it off of a couple of old baseball caps. The whole point is to keep you in an extended state after hanging, which some speculate could help to accelerate the lengthening process. I find that this is a good substitute for hanging a lock or some other such device for ADS. It is far less conspicuous than having such a large object bouncing around under your clothes. Also, I tied a knot in the end of the glove after inserting it through the loop in the plastic snap, to prevent it from coming out after I attach it.

Where is this template you are talking about? I have looked and looked for it with
no luck?

The enlargerstrap website has a template for sizing your purchased strap as well as enough information to make your own.

Thanks
koooky

After looking over the website, I don’t see the template any more. Keep in mind that this is an old post, the site has changed since then. However, if you look at the picture of the enlarger strap on the site you should be able to duplicate the shape by tracing it out on a rubber glove with a marker.