Cock Ring Shock Routine

Another of my posts from PE Forums that I wanted to share with Thundersplace:

I have been experimenting with wearing cock rings for extended periods of time
to maintain engorgement and with hopes of passively increasing girth. After many
months of trying different cock rings and wearing them for gradually longer
periods of time, I have developed the following routine for extended cock ring
wear:

After my morning jelq and stretch routine, I immediately put on a 1.5 inch inside
diameter "Super Stretchy Latex Rubber Ring" around both dick and balls. I kegel
hard several times to pump up the engorgement. I then put on a "Mega Stretch
Silicone Pleasure Ring" around the base of my shaft. Again, I kegel hard while
pulling back on my dick to engorge the shaft. At this point, my mushroom head
becames more than fully enlarged and all the veins in my dick become more raised
and visible. It’s an awesome feeling! I then jump in the shower. I continue to
kegel and pull back on my dick periodically to fluff up and maintain engorgement
while showering. I remove both rings to wash my genital area thoroughly, wash
both rings with soap and then I put the rings back on. After my shower, I towel
off and remove both rings. I continue with my morning preparations.

Just before getting dressed, I put on a 1.75 inch rigid "doughnut-style" rubber
ring around both dick and balls. Again, I kegel strongly and fluff up. I apply cocoa
butter to my glans and the upper part of my shaft (for repairing any irritation
from my morning jelq and squeeze session and to heal spots and stretch marks)
and then put on the small diameter "Super Magic Fun Ring", being careful to avoid
the cocoa butter on the head and upper shaft. I place the small diameter "Super
Magic Fun Ring" around the base of my shaft. I have found that this ring provides
a little more compression than the "Mega Stretch Silicone Pleasure Ring."
Alternatively, I have used a hair elastic; however, the Super Magic Fun Ring is
much more comfortable with no risk of pinching tender dick skin. I then kegel
strongly to engorge the shaft and head beyond normal erection girth while pulling
my shaft back towards my body. I can visibly see the bottom chamber of my
shaft expand when I kegel!

Again, always multitasking, I continue to fluff and maintain the engorgement while
making the bed, etc. I then get dressed and leave for work, still wearing both
cock rings. During my morning commute, I do my morning Kegel/PC muscle routine
while driving to work.

After I arrive at my office, I remove the "Super Magic Fun Ring" because I don’t
like to wear compression-type rings longer than one hour at a time. I continue to
wear the 1.75 inch inside diameter rigid rubber "doughnut-style" ring for the rest
of my workday. I do my evening Kegel/PC routine while driving home from work. I
remove the rigid rubber ring after I arrive home in the evening. When I remove
the cock ring, my balls are hanging large and full and my shaft often involuntarily
engorges. I leave the rigid rubber ring off until bedtime.

At bedtime, I put on a 1.75" "heavy duty" rigid rubber ring or the 1.75"
"doughnut-style" rigid rubber ring around both dick and balls. I go to bed and let
the blood flow do its magic. Mistered was fond of doing PE while in a reclining
position in a "relaxed" mode because of bloodflow considerations. You rarely get
"turtle dick" while relaxing and reclining! I then do some more girth expansion
exercises (kegeling and pulling on the shaft) until I fall asleep with the cock ring
still in place around both dick and balls. I don’t recommend doing this with a
compression-type ring or a ring around the shaft only. Wearing the cock ring
overnight helps enhance the engorgement from morning woodies and keeps
everything in an enlarged state; hopefully stretching the tunica and promoting
growth.

P9 once mentioned that he had a friend that constantly wore a cock ring. The
friend eventually developed a girth of 7 inches. I am doing this routine in hopes of
achieving similar girth gains; however, I would be happy to get to 6 inches.

This routine is for those experienced in wearing cock rings and is potentially
dangerous if proper care is not exercised. See the following threads for
information regarding the rings mentioned above:

http://www.pefo rum.net/forum/s … =&threadid=5360

http://www.pefo rum.net/forum/s … =&threadid=2906

One thing that many cock ring neophytes do not realize is that a properly fitted
cock ring allows bloodflow into the genitals and partially restricts the bloodflow
back out. As a “grower”, I have to constantly fluff to maintain engorgement. The
more aroused I am, the more the blood is trapped and stays in my dick. Without
fluffing attention, I eventually go soft. If I am fully soft, the cock ring allows the
free exchange of blood into and out of the genitals. You will not have an erection
the entire time that you wear a cock ring for an extended period of time;
however, given the proper arousal your erection will be enhanced. I believe that
my cock ring shock routine would be most beneficial to those who have the
privacy to fluff up every couple of hours or so during the day.

I have also noticed that all-day cock ring wear seems to engorge my balls and
has made them a little fuller. It takes some time to get use to the sensation of
something around your balls and pressing on your inner thighs. At first, I never
thought I would be able to wear a cock ring for so many hours because I spend
most of my day sitting at a desk. I seem to be getting used to the sensation. I
especially like the rigid rubber rings because they flex a little; thus, they are more
comfortable than metal rings.

Tried a variation on the evening portion of my routine. At bedtime, I put on a

1.75” “heavy duty” rigid rubber ring, fluffed up and then put the small diameter

“Super Magic Fun Ring” around the base of my shaft. I went to bed and did about

45 minutes of kegel/engorgement exercises. Needless to say, the added

compression of the Super Magic Fun Ring was impressive. Massive girth with a

club-like mushroom head. I was pumped to the max. I have never felt so thick in

my life. I’d love to have that kind of girth and size in my pants all the time. It felt

awesome. I could definitely feel the tunica and head being stretched and veins

were popping out everywhere. I then removed the Super Magic Fun Ring, and did

a few more minutes of kegel/engorgement exercises, then went to sleep.

Sounds very interesting. I could definately use some girth.

Hey J Meister,

Did this cock ring routine produce good results?

The past few days I’ve been doing something similar. I didn’t really intend to get into this, just wanted to try something new while taking a few days off from hanging.

I made a ring out of 1/4” tubing (cost all of $.21 after tax for enough to make 2). It’s 1.75” ID. Today, in addition to getting erect several times an hour, I wrapped the shaft at the base for 10-15 minutes about every 30 minutes. After 5 hours of this I had too much fluid buildup to continue, so I rested about 6 hours and am now back at it.

hobby,

In answer to your question:

Did this cock ring routine produce good results?

Well, like pumping, at first the girth gains are only temporary. However, over time, it seems that my penis’ capacity for increased blood flow has increased. Cock ring wear has increased my erect girth at least 0.25” and has greatly enhanced head girth, giving me an even more pronounced mushroom head with girth approaching 6” around the coronal ridge. So, I would have to say that the results have been good since these are mostly “passive” exercises.

My latest cock ring shock routines have involved stacking multiple rings around the base of the balls and on the shaft, along with the “doughnut-style” rigid rubber ring “anchor” around both dick and balls. I will post more details when I get a chance.

How did you fasten the ends of the 1/4” tubing together to make a ring? Did you use vinyl tubing or rubber surgical tubing?

Good luck with your routines.

Cool. .25” is nothing to sneeze at. Actually, very good.

I used 1/4” OD clear tubing, the stuff sold by the foot. It isn’t stretchy like surgical tubing. I stuck the ends over a short stub of steel rod (see attached pic), though most anything of the correct size could be used. Advantages:

1) cheap
2) easy to make any size
3) flexible - makes it easier to put on

hobby,

Thanks for the pic of your homemade cock ring. Actually, after posting my question, I read another thread where you explained how you made it.

As promised in a previous post in this thread, I am now posting details of my latest cock ring shock routine. I call this the stacked ring shock routine, Here it is:

Put a 1.75” rubber “doughnut-style” ring around both dick and balls. This is the base that “anchors” the whole setup. Then put 1.5” aluminum Pleasure Rings around balls only. Start out with one ring to get used to the sensation. The first balls-only ring kind of tucks under the rubber doughnut touching on one side of the ring. After getting used to the sensation, add more rings. Currently, I am using five 1.5” aluminum Pleasure Rings around balls only. Be careful that you don’t pinch scrotum skin between the rings. This setup is similar to the rings advocated in the low-hanging balls thread; however, I believe that the rings must be slightly smaller, as I haven’t had any need for baby socks, etc. to keep the rings from falling off. Next, put a Mega Stretch Silicone Pleasure Ring at the base of the penis shaft, as low as possible. Kegel forcefully and watch your dick begin to expand. Next, slide a 1.25” aluminum Pleasure Ring over your glans and onto the shaft, just below the circumsion scar (if you’re cut) or in other words, about 1/3 of the way down the shaft. Finally, slide one or two more 1.25” aluminum Pleasure Rings over the glans and place them on the shaft, immediately below the coronal ridge, i.e., as head rings. The 1.25” rings allow for more shaft expansion and less constriction on the circumcision scar than the 1” aluminum Head Pleasure Rings sold for that purpose.

At this point, you should pump up further with kegels and the overall result should be a mind-blowing bulge. Because the rubber doughnut-style ring and the stacked 1.5” aluminum Pleasure Rings push everything forward and extend your balls downward, together with the engorged shaft, the result is a very impressive “basket.” I have found that putting rings at all these points is synergistic and results in maximal engorgement.

Note: The ring sizes cited above are what I use. You horse-hung guys may find them too small and need to size up.

I like to leave this setup on for at least an hour. I then remove the Mega Stretch Silicone Pleasure Ring (since it is a compression-style ring, I am reluctant to leave it on for hours at a time) and the 1.25” rings on the shaft/head. I then continue to wear the 1.75” rubber doughnut-style ring around both dick and balls and the stack of 1.5” aluminum Pleasure Rings around balls only for as long as comfortable, generally 2 to 5 hours. However, I can wear a cock ring around both dick and balls all day long if I want to.

The Stacked Ring Shock Routine seems to work the entire package. This is a routine for experienced cock ring wearers who want to take it to the ultimate level. I have described the cock rings mentioned above in detail in my “The Wonderful World of Cock Rings” thread. I’d like to get others’ impressions of using cock rings at multiple points simultaneously.

I don’t quite use as many rings as you do J., but after my workout, I wear a 1.75” metal ring around my penis and balls throughout the day. The 1.75” is too small to wear with a full erection, but it’s perfect for keeping my penis pumped throughout the day.

Have you gained any length from this routine?