My version of the uli thing

This is my own version of the uli thing.I roll up a piece of elasticated bandage and place it at the base of the penis and then clip two sections drainage pipe over each other and tighten a jubilee clip over the top. I find it very easy to use.
I am experimenting with two length of drainage pipe split lengthways and padded on the inside, once I have clamped with the uli thing I place one on the underside and one on the top of the penis along the length and then use two G clamps to squeeze them together, this greatly increases the pressure especially sideways. I am doing this to try to increase the width of my penis.Although in the early stages of experimentation, it seems promising.
This is not an experment for newbies.Exercise great caution.

Along

How did you get the nice smooth edges on the plastic?

The elastic bandage is a good idea, I had problems with cloth bunching up with a similar device, does it bunch much?

Jubliee clips can be got with wing nuts so you dont have to use a screw-driver or spanner (please use a spanner if you must, screwdrivers and cocks dont mix!)

Hi Trigger

I used a Bastard file and I`m not swearing when I say this,as this is what its called and emery paper or glass paper.

The bandage doesn`t bunch up when its new, but as it loses its elasticity it does. Get the smallest size possible.

Cheers.

Hi guys,

I also made myself a Uli thing.
In place of the wrapping protection i use a piece of pipe isolation(the stuff used to isolate air conditionning pipes).
I cut a 1 inch piece of pipe isolation and adjust it to my dick.
For clamping i use the regular hose clamp like Along has.
Very efficient and very cheap to make.

Portugesus