Penimaster Math

Well, I may be jumping on the PM bandwagon in a month or two. I figure with a good deconditioning break I should be able to make some gains with the PM.

Before I buy one, though: How long does it take to put the PM on? That is, how long will each “break” be (every 60 to 90 minutes) during which I revive my penis?

Also, those of you who have bought from pmdevice.com/jelqdevice.com (rather than the manufacturer), have they honored the 3-year warranty when you needed replacement parts?

I also have a question:

Can this device be worn under clothing without it being too noticeable?

KOG, from what I’ve read, yes, as long as the pants aren’t too tight. Apparently it just looks like you have a big dick, if anything.

I don’t own a pair of pants that this thing would hide under (and I do have some pretty baggy boarding pants too). It’s about 2 1/4” wide, and as long as your erect penis.

Para,

It only takes a minute or two to put the PM back on, once you find the right setting for you. It took me about a week to find my ideal setting with wrap.

I personally use Johnson & Johnson First Aid Hurt-Free Tape, about 12 to 15 inches to wrap… Rather than using the cloth that comes with the PM. As far as breaks, I check in that time range of 60-90 minutes and give about 5-10 minute break. I have been clocking some decent hours with it, since I wear it while I am at work.

I hope that helps.

mm

mm,

Thanks so much!

What exactly is involved in “wrapping” for a PM? Is it a pain-in-the-ass process at first, as it is with wrapping for hanging, or is it less difficult to get “just right”??

I would say it is easier than wrapping for hanging. I just started wearing my penimaster today and I had no problem getting the wrapping to work the first time. Just take a small piece of t-shirt or the sleeve they give you and wrap maybe an inch from the glans.

I have created a traction calculator using the above formula.

It’s coded in JavaScript & the GUI is in HTML.

Here is a preview of it:

http://www.geoc ities.com/westg … ractionCalc.htm

I made it because the other calculators I tried don’t even work on my PC, & because I thought it would be useful to have one at Thunders, maybe in the traction section of the tutorials.

At 12 hours a day that makes 83 days for an inch (1000 hours for 1.01inches)

Having worn a Penimaster for hours and hours and hours I’d have to say that it sounds a little optimistic to me, but it could be feasible.

I gained 1.5 inches over sixteen to seventeen months, but I was hanging for a few months also.

I think the basic data given at the traction device sites might not be entirely dependable.

Also— I was under the impression that gains from traction devices (like the Penimaster) had a tendency to slow in relation to the growth they promote.

At any rate, it’s a cool calculator (I’m just not sure about the accuracy of the figures on which the calculations are based).

Made some improvements but the code is a mess again :P

I also added expected girth but now I’m doubting that the same formula applies for expected girth gains.

If you have any ideas to improve the formula please post & discuss.

If changes are agreed upon I can apply them.

Changes:

-Removed expected girth

-Added total hours used

-fixed bugs

Wow, that’s cool.

Just one hour a day, 6 days a week, for a year, should net a 6% increase.

Hey Martin,

Do you think all the peoples have the same gain potential? I don’t think so…

This is the formula the Jes Extender site uses, it’s just a prediction.

The PE survey results could provide the necessary data for a more precise calculator but the results would need to be analysed & formula created by people that are highly knowledgeable in penis enlargement, not me.

The only way to know if the current formula is accurate is for people to correlate there gains with the calculator.