Anywhere I can get larger size penis extender bases?

I have very fat girth flaccid, over 6”, and the penis extenders will not fit down over my penis, or they will get stuck and I can’t get them off even with lube. Actually had to cut one off onetime as my dick started to turn purple and would not come off. Even the C shaped ones that you can get a few places just squeeze too hard at the base and cut of blood flow. Just wondering if there is a stretcher out there to accommodate guys that are naturally girthy when flaccid?

I think LG Hanger can custom made it for you.

I have the same issue with a large girth. All I found was an inexpensive base on eBay that was larger but only on the top and bottom, not the sides. It is more oval in shape. It still tight so wearing time is limited. But it works in a pinch lol. I can’t recall the name but I believe it was something like LeLuv. Good luck

LG did made a custom extender for someone.

He claims it can generate 10lbs tension too .

Thanks, I’ll send him a message and see what he says.

I would also be interested in what you learn.

There was another forum member who was going to make a larger base for the X4. I tried the X4 extended wide girth base. It helped for short while but now it gets tight. Almost like wearing a cock ring. Not what I want to do while extending.

I tried the X4 wide base and it wasn’t wide enough. It is only taller. Side width is the same. Thanks.

You maybe interested in this:

Large Girth Extender (p. 2)

So I emailed LG Hanger, and he said that he could make me a custom base. I hadn’t purchased his system as it seemed a bit more than I wanted to spend, but watching his videos with his extender adapter kit, I think I may go ahead and do so.

You can get the LG ADS and maybe tweak with monkeybar Vac ADS chamber.

But it will be a good investment. I am waiting for my LG chamber then may go for ADS too.

If you don’t mind a little legwork, mjana created some 3d print files (find the post “3D printable penis extender adaptation for X4labs and MonkeyBar Vac Extender”). The files he made are meant to replace an X4 extender base with a modified top, so he could use monkeybars’ vac. The opening is a little over 2”, but you could probably modify that or ask at the 3d printers if they could if you need it larger.