Vac Cap Extending

I really like extending in a rod extender using a vac cap….. BUT, because my cap is wider then the rods, I wear holes in the silicone sleeves far too rapidly. The wear spot is always the same, the widest point of the vac cap.
I have added tape around the extenders rods were the cap comes in contact but that doesn’t really help much.

What fixes have some of ya’ll found to work?

Hmmm…

I’m thinking that you need to put something soft between the rods and silicone. A little bit of felt might work.
The idea is that you’ll want something that will cushion, reduce or eliminate friction, and stay in place.

I’ve tried even a soft fabric between the vac chamber and the bars but still run into and have the same issue. It seems even just resting against the bars with a cloth in between is enough to ruin it. I’m guessing it has something to do with the tension on the silicone sleeve in this position since it is also pulled tight from the vacuum hold.

This method of PE is by far the most productive for me. Normal extending doesn’t work for me for about 6 different reasons, and vac extending finally solved it and beats hanging for me as well. The issue is that I either need to ensure the sleeves last longer or need a source of sleeves where the cost is as if they’re disposable.

If I’m able to use the same silicone sleeve around the vac chamber 3 times it’s an achievement.

I’ve recently started using some toe guard silicone sleeves but even these aren’t disposable enough and wear out even faster.

Is there any way to buy the silicone sleeves cheaper or to preserve them longer?

(Also going to need more bars soon, I’m at the max it came with but with the vac chamber I’m at the right tension with it exactly at max).

Need some advice. Started extending use the vac extender from autoextender. Problem is I got two blisters on the head of my penis near the urethra. I felt no discomfort and probably was only extending for three hours with some quick breaks. I had taped with micro-foam tape over the urethra as I tend to get some swelling there from ADS. THen I put on a glans cap and taped it three times once verticle to then two horizontal strips so the glans was totally covered. I think there must have been a little moisture possibly from precum as after the first hour was just trying to get some blood flow an erection before letting it die down and get a better tape on it, but I tend to make a lot of precum naturally so I think some dripped in. I am hoping that it was just the moisture that caused it, and should be relatively easy to avoid in the future. But now I imagine with these two blood blisters It will be at least a week until I can do anything else. I would post pictures but it won’t let me. How do you avoid blisters, I don’t think the pressure was superhigh as it it just has a suction tube you suck the air out with.

I am thinking trying to put a small hole in the toe protecter I am using for a glans protection cap so it doesn’t bunch up, and some powder inside as well. Cover the glans with surgical masking tape since it comes off easy. I am healing fast, I sterilized a needle to drain the blisters and wiped with alcohol, that hurt, then put some neosporin on it and can barely tell it happened. Might try again this weekend and keep a close eye on it with a few more breaks.

GIAS,

I used to is the glans protective cap from Phallosan Forte, it worked decent to protect the glans.
My issue came when I was hanging 15+ pounds with the vac cap. No blisters but the skin was toughening up a bit and was more pink/red then normal.
I tried a new cap (if you google search ‘penis silicap’ you will find it) and holy shit this thing made a huge deference.
Protected the glans much better and even with continued hanging my skin healed.
I am a fan…