Homemade Extender the T-Bone
Hey guys. It’s been a while, but hopefully I’m back steady for a while.
I wanted to share the latest homemade device I’ve been using.
It’s made from easy to find parts and the end result is a durable, reliable stretcher.
The threaded lamp rod device within the head allows you to fine tune the fit of the noose, rather than untying and tying it till you get it right. Once it’s right, its good to go for months. (I haven’t had to re-adjust mine in the past 6 months)
The center piece of pipe is removable and replaceable and as your penis grows, you add a slightly longer piece of pipe to accommodate your growth.
The base I made is from a solid piece of plastic that was drilled and tapped for the rods to screw directly into (so the nuts are not needed), but I also attached image instructions to make use of a 2” plumbing cap to secure the rods with 1/4” nuts.
Edit: This design was designed to fit my current size (and I certainly couldn’t have started my PE career in it) and will probably not work for a NBP of 6.5” or less because the lower tee fitting uses up a lot of space. If you don’t think the design will work for you maybe check out a older design (Lightning Rod) whose construction allows for a much wider range of lengths. :)
(75.1 KB, 1708 views)
(73.4 KB, 1257 views)
(72.6 KB, 986 views)
(71.2 KB, 1042 views)
(41.4 KB, 1217 views)
Keep an open mind and a closed wallet... unless it\'s open to making a donation!
Last edited by cantlook : 12-02-2013 at .