Is it normal for extenders?

I bought a Andropenis extender a couple weeks ago. I am doing the special method as I am young and my body heals quickly. Supposedly the springs should apply tension but they are not being used at all where I am in the guide despite being past my old stretched length. Is this normal? Will they start being used with more spacers? Will this typically still make gains? Thank you for reading.

Not everyone’s dick responds the same in an extender. I find that using tension is the best guide. Check your instructions to see if there are lines etched on the base rods of the extender.

Normally, you should have the first of three lines just exposed for beginners. On my X4 this position represents 500 gr of tension. Your instructions should tell you how each line is calabratet.

If you are not at the first line when mounted, you need to turn the knob until the first line is just showing. If the first line is then not just about to be covered you need to add more spacer rods.

So I am just at 30 days starting today. The flaccid gains are ridiculous. Always turtled extremely hard but went from like a 2” flaccid to a 4”. I cheated a bit, and in the last 30 days, I have logged 142 hours not the recommended 120. No erect gains yet, of course, but I am excited for the future.

I have no lines whatsoever on the device. I’m guessing the solution to this is to push down on a kitchen scale and mark off the positions?