Bib, Your advice?

Hi Bib. I have a question about wrapping. I’ve had my hanger for just over a year and have used it on and off. I get going but because of problems with slipping, pressure on the head, etc. I get discouraged and shut it down for a while. Then, I start again, trying different ways to wrap, different materials, different combinations of toe-in/out etc. Try as I might, there is only one way that seems to work semi-consistently. I have to be at a partial erection, then wrap from the base. Then I attach the hanger close to the base and tighten while squeezing blood from the head. This is the only way I can get it to stay without slipping. It doesn’t, however, provide much room for fulcrum hanging. If I do get a finger under and behind the hanger and lift for the fulcrum effect, the hanger then usually slips forward and it’s back to square one again. I think being uncut is part of the problem, but damn I’d like to find a way to make this work consistently. I should mention that I’m pretty sure the ligs are being stressed as I can feel behind the hanger and it’s hard as rock with 10 lbs attached. I guess what I’m asking is: Is this ok? will I still get results even though the hanger is back towards the base? Any advice or suggestions are greatly appreciated.

masterbuilder

MasterB,

>I guess what I’m asking is: Is this ok? will I still get results even though the hanger is back towards the base? Any advice or suggestions are greatly appreciated. <

I cannot say that you will not get results, but more than likely, you will only be stretching skin for now. But fear not, we can get your problems worked out. Do you have the capability to send me pictures? The guys that have been sending me pics of their setup seem to be having a lot of luck. It is much easier to see the problems, rather than trying to form a picture in my head from a description.

If not, then please tell me exactly what you are doing, amount and type of wrap, top and bottom gaps, type of hanger, dimensions, etc.

I have not heard of too many problems from uncut guys in a while. As far as slipping goes, I always return to the question of whether you are tightening enough. At some point, there should be enough pressure to firmly attach the hanger, especially at only ten lbs.

Give me as much information as possible, and I will try to help.

Bigger

Sending pics sounds like a great idea! I have a web cam that takes photos and a cheapy digital camera, so I should be able to figure out something. Two questions, would I post the pics here or send them to you elsewhere and, 2, what exactly do you want to see? Picture of the hanger and it’s settings? various stages as I wrap? etc. Please let me know and I’ll put something together for you. <But fear not, we can get your problems worked out> I sure hope so, I’m not getting any younger :)

Masterbuilder

MasterB,

>Two questions, would I post the pics here or send them to you elsewhere<

You can post them in the members pics forum, but not in here. Or you can email them to me at bib_hanger@hotmail.com.

>and, 2, what exactly do you want to see? Picture of the hanger and it’s settings? various stages as I wrap? <

Wrap, if more than one layer, then a pic of each. Then, a pic of the tightened, attached hanger, top and bottom, so that I can see the settings.

Be sure to include your dimensions, especially the wrapped flaccid girth. Also, please include the exact problems you are having, and any other pertinent information so that I can have everything together.

Bigger