Cool idea for an ADS: Repost from Bib's forum

What if you took a cylindrical object.. lets use a toilet paper roll for instance, and used some kind of rope, maybe a bungee cord, to secure it just below the base of your penis (as if it were a small RSDT) then secure the cord around your waist so it stays there hands-free.

Now, if you use a conventional ADS like golf rings or a vacu-hanger to hang some light weight downward off the penis, while this cylinder is jammed between the shaft and your balls, wouldn’t that be like a light all-day RSDT hang?

Necessity being the mother of invention, I daydreamed this on one of my 8-hour shifts at my retail job, wishing I could be hanging.

I’ve been experimenting by securing a golf ring at the base of my penis using small cords that attach to my belt, while I use more golf rings to extend the penis downward, imitating a wantsmore stretch, and holding it for 6+ hours on end. I feel no real fatigue during the 6 hours, but notice that during hanging sessions afterwards it’s a lot harder to reach fatigue on the RSDT. Healing in the extended state, maybe? I hope.

Oh, by the way BIB - I found a way to circumvent the fluid buildup that happens when I use my circle device. (This is a golf ring-style ADS except it looks more like a claw that you can open and close) I used your model of wrap loose hanger tight. I wrap lightly with t shirt material and make sure that the rubber bands I wrap around the circle device are almost pinching my member. You have to undo it every 20 minutes to restore circulation this way, but there’s almost no fluid buildup in the foreskin.

I know you’re not big on ADS, but I remember much more rapid gains when this was part of my routine, so I’m adding it back in.

~L

I’m having some trouble imagining this set up. Could you provide pictures? They could be actual pictures, drawings, or even cgi :) Thank you.

This is the best picture I could draw. It is a graphical representation of my current golf-ring ADS setup.

~L

Your idea would have been clearer if you had rewritten your post. I had to read it a few times to get it.

A penimaster type stretcher already does what you describe, the base gets up pushed because of the tension applied and puts the suspensory ligament out of the equation putting the tension on your entire tunica. In theory I’m sure your idea would work for an ADS like golf rings or a vacu-hanger but I’m not sure it would be practical. I think the upward force of the ring at the base would lower during use because anything it’s attached to will lower. Unless you would be willing to wear a very tight belt.

I have seen a contraption for a vac type stretcher that could be worn around your neck and shoulders for upward use. You could try using something like that to keep a ring at the base up.

I do think if you find a practical way for this to work it could benefit a lot of ADS users.

I did see the penimaster, that’s a cool gadget right there. Also, on the VACXtender page there’s a device that looks like it does something similar.

Autoextender Penis Enlargement Device - It’s the picture labeled "Auto V stretch"

It looks like it would all depend, as you were saying, Piet, on the amount of tension you could keep constant on the fulcrum (in other words, the upward pull on the golf ring/toilet paper roll/etc.)

When I tie it off with cords at the belt, it does take re-adjusting and tightening every hour or so.

Only problem so far is I feel no wear and tear on the tunica after 5 or 6 hrs of use. But I might be conditioned because I hang 10+ lbs off an RSDT 6-12 sets a day.

Anyone else care to try this out and report? Has anyone used that Auto V Stretch?

~L