Dangers of clamping front to back and on the glans

I find it easier to clamp a homemade bib hanger front to back rather than on the sides of the shaft. Even when i tried on the sides it slipped around due to the penis being wider in that direction. What are the dangers of this?

Also is it harmful to clamp on the glans past the ridge? I tend to stretch manually by holding the glans and find it much easier this way. by clamping on the glans i presume you will be also stretching the area below the glans which is usually clamped so would you get more gains?

Theres a very fragile nerve structure in the front, below your glands. You DO NOT want to put any pressure on it, if you want to keep a healthy penis. Impotency and desensitivity are two of the hazards.

Yes it is. I don’t think there is any benefits in hanging like that. The areas that we are trying to stretch are ligaments located in your pubic are and tunica located behind your testicles (well it is located in quite a wide area, but that’s where you usually feel the stretch). Also, you don’t want to have any desensitivity issues from putting the stress on your glands, right?

Thanks base. I just find it difficult to keep the hanger from dragging down to the glans since I have lots of foreskin. Have to just practise wraps more i guess.

How do you wrap? When I wrap, I pull out the fore skin, but not all straight, just to let the glans vicible, so that most of the extra foreskin kinda bundles above the glands.

That’s the problem with homemade hangers. I had the same problem; my penis twisted 90 degrees when I was attaching the hanger. I guess one way to solve the problem would’ve been to make the hanger more round in the middle, more natural for penises shape, than just two sticks. I solved the problem by buying a Bib and that truly worked, they’re out of stock now, though.
What kind of hanger do you use? What have you made it of?

It is 2 rectangular plates of steel with holes on each corner. They are hammered into a slight bend so it sort of matches the round shape. Then I screw in 4 nuts and bolts a bit at a time until they close up together evenly. I have some silicon sealant on the plates for grip and padding. I tie strings onto the bolts between the 2 plates for my weight.

I had been pulling the foreskin back as far as it would go and when tightening the clamp I would again gather skin back towards the base, I will try what you suggest and see how it goes. I wrap with just cotton.

trigger,

You have several problems there. No this, you are on the wrong track. Do not hang with the pressure on top and bottom. You may be ok for a while, but the odds are, you will soon notice numbness. Please learn from the experience of others and don’t go there.

As far as you hanger, steel is not a very forgiving material on the penis. Try to make your hanger out of PVC or something a little easier to work with. You will probably need to modify your design to fit you better.

Make sure that whatever you wrap with is elastic, and wrap loose. A non-elastic material can end up acting as a noose.

Bigger

Thanks Bib. The steel has a thick coat of silicon on it so it is ok. I have since got the hang of clamping on the sides, all I need to do is adjust the screws slowly one by one so both sides clamp the same. I have ideas for other hangers but this one works fine now. I am still using low weights until I am totally pleased with it.